There is a group of PHY chips supporting BroadR-Reach link modes in
a manner allowing for more or less identical register usage as standard
Clause 22 PHY.
These chips support standard Ethernet link modes as well, however, the
circuitry is mutually exclusive and cannot be auto-detected.
The link modes in question are 100Base-T1 as defined in IEEE802.3bw,
based on Broadcom's 1BR-100 link mode, and newly defined 10Base-T1BRR
(1BR-10 in Broadcom documents).
Add optional brr-mode flag to switch the PHY to BroadR-Reach mode.
Signed-off-by: Kamil Horák - 2N <kamilh@xxxxxxxx>
---
Documentation/devicetree/bindings/net/ethernet-phy.yaml | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 8fb2a6ee7e5b..0353ef98f2e1 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -93,6 +93,13 @@ properties:
the turn around line low at end of the control phase of the
MDIO transaction.
+ brr-mode:
+ $ref: /schemas/types.yaml#/definitions/flag
+ description:
+ Request the PHY to operate in BroadR-Reach mode. This means the
+ PHY will use the BroadR-Reach protocol to communicate with the other
+ end of the link, including LDS auto-negotiation if applicable.
+
clocks:
maxItems: 1
description:
--
2.39.2
