On Tue, Mar 03, 2015 at 02:20:31PM +0100, Hans de Goede wrote:
> Hi,
>
> On 03-03-15 09:22, Maxime Ripard wrote:
> >On Tue, Mar 03, 2015 at 08:55:36AM +0100, Hans de Goede wrote:
> >>>>+/ {
> >>>>+ model = "Mele I7 Quad top set box";
> >>>>+ compatible = "mele,i7", "allwinner,sun6i-a31";
> >>>>+
> >>>>+ chosen {
> >>>>+ bootargs = "earlyprintk console=ttyS0,115200";
> >>>
> >>>Using earlyprintk by default is a bad idea if the kernel is configured
> >>>with DEBUG_LL support for another SoC.
> >>
> >>While on this subject, u-boot now sets the chosen/stdout-path property
> >>up by default, which means that the kernel will do the right thing by
> >>default. So we we really do not need any bootargs= in our dts files.
> >
> >I just tested that this weekend, and it turned out that the kernel
> >couldn't use it so far (ie, no output until init takes over and setup
> >a TTY on ttyS0).
> >
> >Was it working for you?
>
> Yes, note that the kernel only honors the stdout-path property if
> there is no console= argument present if there is a console= argument
> present on the kernel cmdline then that will overrule the stdout-path
> property
Yeah, I removed the bootargs entirely.
> Which board did you test with, and what u-boot and kernel version ?
I tested it on my A31 hummingbird, with allwinner's u-boot, but with
/chosen/stdout-path hardcoded to "serial0:115200n8", with a 4.0-rc1
kernel.
But it might very well just be me. We just tested it on a Marvell
board (that uses the same serial driver) this morning and it was fine,
so I don't think it's really worth worrying about this :)
> >>Currently we've a random mix where we do have bootargs in some, but
> >>not in most sunxi dts files. I believe we should simply remove it
> >>everywhere...
> >
> >We used to set them in SoCs that are not supported by U-boot yet, and
> >where the bootloader won't come and patch the DT (A31, A23, A80).
>
> Ah, so that is (was) the logic, following that logic we should probably
> remove bootargs= from at least the a23 and a31 boards (basically
> from all boards but a80).
I'm not so sure about the A31, since most boards won't even boot by
default on the SD card, and we have no way to replace U-Boot in NAND
so far (afaik). But replacing them by stdout-path is a very good
solution too.
Maxime
--
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
Attachment:
signature.asc
Description: Digital signature
