On 6/17/24 1:23 PM, Christophe ROULLIER wrote:
Hi,
+static int stm32mp2_configure_syscfg(struct plat_stmmacenet_data
*plat_dat)
+{
+ struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
+ u32 reg = dwmac->mode_reg;
+ int val = 0;
+
+ switch (plat_dat->mac_interface) {
+ case PHY_INTERFACE_MODE_MII:
+ break;
dwmac->enable_eth_ck does not apply to MII mode ? Why ?
It is like MP1 and MP13, nothing to set in syscfg register for case MII
mode wo crystal.
Have a look at STM32MP15xx RM0436 Figure 83. Peripheral clock
distribution for Ethernet.
If RCC (top-left corner of the figure) generates 25 MHz MII clock
(yellow line) on eth_clk_fb (top-right corner), can I set
ETH_REF_CLK_SEL to position '1' and ETH_SEL[2] to '0' and feed ETH
(right side) clk_rx_i input with 25 MHz clock that way ?
I seems like this should be possible, at least theoretically. Can you
check with the hardware/silicon people ?
As a result, the MII/RMII mode would behave in a very similar way, and
so would GMII/RGMII mode behave in a very similar way. Effectively you
would end up with this (notice the fallthrough statements):
+ case PHY_INTERFACE_MODE_RMII:
+ val = SYSCFG_ETHCR_ETH_SEL_RMII;
+ fallthrough;
+ case PHY_INTERFACE_MODE_MII:
+ if (dwmac->enable_eth_ck)
+ val |= SYSCFG_ETHCR_ETH_REF_CLK_SEL;
+ break;
+
+ case PHY_INTERFACE_MODE_RGMII:
+ case PHY_INTERFACE_MODE_RGMII_ID:
+ case PHY_INTERFACE_MODE_RGMII_RXID:
+ case PHY_INTERFACE_MODE_RGMII_TXID:
+ val = SYSCFG_ETHCR_ETH_SEL_RGMII;
+ fallthrough;
+ case PHY_INTERFACE_MODE_GMII:
+ if (dwmac->enable_eth_ck)
+ val |= SYSCFG_ETHCR_ETH_CLK_SEL;
+ break;
[...]
