From: Marek Vasut <marex@xxxxxxx> Trivial, fix up the comments using 'Mhz' to 'MHz'. No functional change. Signed-off-by: Marek Vasut <marex@xxxxxxx> Signed-off-by: Christophe Roullier <christophe.roullier@xxxxxxxxxxx> --- drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c index 75981ac2cbb56..bed2be129b2d2 100644 --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c @@ -58,7 +58,7 @@ * Below table summarizes the clock requirement and clock sources for * supported phy interface modes. * __________________________________________________________________________ - *|PHY_MODE | Normal | PHY wo crystal| PHY wo crystal |No 125Mhz from PHY| + *|PHY_MODE | Normal | PHY wo crystal| PHY wo crystal |No 125MHz from PHY| *| | | 25MHz | 50MHz | | * --------------------------------------------------------------------------- *| MII | - | eth-ck | n/a | n/a | @@ -367,7 +367,7 @@ static int stm32mp1_parse_data(struct stm32_dwmac *dwmac, /* Gigabit Ethernet 125MHz clock selection. */ dwmac->eth_clk_sel_reg = of_property_read_bool(np, "st,eth-clk-sel"); - /* Ethernet 50Mhz RMII clock selection */ + /* Ethernet 50MHz RMII clock selection */ dwmac->eth_ref_clk_sel_reg = of_property_read_bool(np, "st,eth-ref-clk-sel"); -- 2.25.1
