Re: [PATCH v5 08/12] net: stmmac: dwmac-stm32: add management of stm32mp13 for stm32

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 6/7/24 11:57 AM, Christophe Roullier wrote:

[...]

@@ -224,11 +225,18 @@ static int stm32mp1_configure_pmcr(struct plat_stmmacenet_data *plat_dat)
  {
  	struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
  	u32 reg = dwmac->mode_reg;
-	int val;
+	int val = 0;

Is the initialization really needed ? It seems the switch-case below does always initialize $val .

  	switch (plat_dat->mac_interface) {
  	case PHY_INTERFACE_MODE_MII:
-		val = SYSCFG_PMCR_ETH_SEL_MII;
+		/*
+		 * STM32MP15xx supports both MII and GMII, STM32MP13xx MII only.
+		 * SYSCFG_PMCSETR ETH_SELMII is present only on STM32MP15xx and
+		 * acts as a selector between 0:GMII and 1:MII. As STM32MP13xx
+		 * supports only MII, ETH_SELMII is not present.
+		 */
+		if (!dwmac->ops->is_mp13)  /* Select MII mode on STM32MP15xx */
+			val |= SYSCFG_PMCR_ETH_SEL_MII;
  		break;
  	case PHY_INTERFACE_MODE_GMII:
  		val = SYSCFG_PMCR_ETH_SEL_GMII;

[...]

This way of adding MP13 support definitely looks much better.

Also, split the series, drivers/ stuff for netdev (and make sure to include the net-next patch prefix , git send-email --subject-prefix="net-next,PATCH") , DTs for linux-arm-kernel , config patch also for linux-arm-kernel .




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux