On 26.02.2015 21:01, Stephen Warren wrote:
On 02/26/2015 12:39 PM, Sebastian Hesselbarth wrote:
On 26.02.2015 18:55, Gregory CLEMENT wrote:
On 17/02/2015 19:52, Sebastian Hesselbarth wrote:
This patch set improves current mainline support for the Compulab
CM-A510 System-on-Module (SoM) and its default Compulab SBC-A510
base board. Thanks to Gabriel Dobato who agreed to remote debug and
test the provided DT changes.
[...]
Sebastian Hesselbarth (8):
i2c: mux-pinctrl: Rework to honor disabled child nodes
devicetree: vendor-prefixes: Add CompuLab to known vendors
ARM: dts: dove: Fix uart[23] reg property
ARM: dts: dove: Always include gpio and interrupt-controller headers
ARM: dts: dove: Add node labels for PCIe ports 0 and 1
ARM: dts: dove: Add some more common pinctrl settings
ARM: dts: dove: Add internal i2c multiplexer node
ARM: dts: dove: Add proper support for Compulab CM-A510/SBC-A510
Patches 3 to 6 applied on mvebu/dt
If I understood well patches 7 and 8 depend on patch 1 which had not
been
taken yet.
Correct. Once I get a Tested-by from Stephen, I'll resend the 4
remaining patches.
Me? For which patch? I thought there was going to be a v2 of the i2c mux
driver patch given the comments on it, but perhaps I'm misremembering?
AFAIKS, your concerns were addressed to the wording of the binding doc
changes. You don't need that ones to be taken care of before you can
give the i2c-mux-pinctrl driver a functional test, do you? ;)
FWIW, it would be great if you can give patch 1 a test run on one of
the tegra boards using i2c-mux-pinctrl. I'll address the wording
comments if there is no issues with the driver changes.
Sebastian
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
