From: Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx> Whilst not documented, register 0x0103 bit 0 is the soft reset for the sensor, so send it before trying to configure the sensor. Signed-off-by: Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx> Signed-off-by: Luis Garcia <git@xxxxxxxxxxxx> Reviewed-by: Pavel Machek <pavel@xxxxxx> --- drivers/media/i2c/imx258.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/drivers/media/i2c/imx258.c b/drivers/media/i2c/imx258.c index c1a2c2406aaa..9c83ba1232fa 100644 --- a/drivers/media/i2c/imx258.c +++ b/drivers/media/i2c/imx258.c @@ -20,6 +20,8 @@ #define IMX258_MODE_STANDBY 0x00 #define IMX258_MODE_STREAMING 0x01 +#define IMX258_REG_RESET 0x0103 + /* Chip ID */ #define IMX258_REG_CHIP_ID 0x0016 #define IMX258_CHIP_ID 0x0258 @@ -1052,6 +1054,16 @@ static int imx258_start_streaming(struct imx258 *imx258) const struct imx258_link_freq_config *link_freq_cfg; int ret, link_freq_index; + ret = imx258_write_reg(imx258, IMX258_REG_RESET, IMX258_REG_VALUE_08BIT, + 0x01); + if (ret) { + dev_err(&client->dev, "%s failed to reset sensor\n", __func__); + return ret; + } + + /* 12ms is required from poweron to standby */ + fsleep(12000); + /* Setup PLL */ link_freq_index = imx258->cur_mode->link_freq_index; link_freq_cfg = &imx258->link_freq_configs[link_freq_index]; -- 2.44.0