Hi Andrey, On Sat, May 04, 2024 at 07:41:14PM +0300, Andrey Skvortsov wrote: > Signed-off-by: Andrey Skvortsov <andrej.skvortzov@xxxxxxxxx> > Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> > --- > .../bindings/media/i2c/galaxycore,gc2145.yaml | 65 ++++++++++++++++++- > 1 file changed, 64 insertions(+), 1 deletion(-) > > diff --git a/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml b/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml > index 1726ecca4c77..3ca5bb94502d 100644 > --- a/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml > +++ b/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml > @@ -61,8 +61,38 @@ properties: > properties: > link-frequencies: true > > + bus-type: > + enum: > + - 4 # CSI-2 D-PHY > + - 5 # Parallel > + default: 4 > + > + bus-width: > + const: 8 > + > + hsync-active: > + enum: [0, 1] > + default: 1 > + > + vsync-active: > + enum: [0, 1] > + default: 1 > + > + pclk-sample: > + enum: [0, 1] > + default: 1 These are relevant for bus-type 5 only. > + > required: > - - link-frequencies > + - bus-type > + > + allOf: > + - if: > + properties: > + bus-type: > + const: 4 > + then: > + required: > + - link-frequencies I think I'd keep the link-frequencies for DVP as well. > > required: > - endpoint > @@ -84,6 +114,7 @@ additionalProperties: false > > examples: > - | > + #include <dt-bindings/media/video-interfaces.h> > #include <dt-bindings/gpio/gpio.h> > > i2c { > @@ -103,6 +134,7 @@ examples: > port { > endpoint { > remote-endpoint = <&mipid02_0>; > + bus-type = <MEDIA_BUS_TYPE_CSI2_DPHY>; > data-lanes = <1 2>; > link-frequencies = /bits/ 64 <120000000 192000000 240000000>; > }; > @@ -110,4 +142,35 @@ examples: > }; > }; > > + - | > + #include <dt-bindings/media/video-interfaces.h> > + #include <dt-bindings/gpio/gpio.h> > + > + i2c { > + #address-cells = <1>; > + #size-cells = <0>; > + > + camera@3c { > + compatible = "galaxycore,gc2145"; > + reg = <0x3c>; > + clocks = <&clk_ext_camera>; > + iovdd-supply = <&scmi_v3v3_sw>; > + avdd-supply = <&scmi_v3v3_sw>; > + dvdd-supply = <&scmi_v3v3_sw>; > + powerdown-gpios = <&mcp23017 3 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>; > + reset-gpios = <&mcp23017 4 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>; > + > + port { > + endpoint { > + remote-endpoint = <¶llel_from_gc2145>; > + bus-type = <MEDIA_BUS_TYPE_PARALLEL>; > + bus-width = <8>; > + hsync-active = <1>; > + vsync-active = <1>; > + pclk-sample = <1>; > + }; > + }; > + }; > + }; > + > ... -- Kind regards, Sakari Ailus