Add SPI NAND support for ipq9574 SoC. Signed-off-by: Md Sadre Alam <quic_mdalam@xxxxxxxxxxx> --- Change in [v6] * No change Change in [v5] * No change Change in [v4] * No change Change in [v3] * Updated gpio number as per pin control driver * Fixed alignment issue Change in [v2] * Added initial enablement for spi-nand Change in [v1] * Posted as RFC patch for design review .../boot/dts/qcom/ipq9574-rdp-common.dtsi | 43 +++++++++++++++++++ arch/arm64/boot/dts/qcom/ipq9574.dtsi | 27 ++++++++++++ 2 files changed, 70 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi b/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi index 91e104b0f865..6429a6b3b903 100644 --- a/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi @@ -139,6 +139,49 @@ gpio_leds_default: gpio-leds-default-state { drive-strength = <8>; bias-pull-up; }; + + qpic_snand_default_state: qpic-snand-default-state { + clock-pins { + pins = "gpio5"; + function = "qspi_clk"; + drive-strength = <8>; + bias-disable; + }; + + cs-pins { + pins = "gpio4"; + function = "qspi_cs"; + drive-strength = <8>; + bias-disable; + }; + + data-pins { + pins = "gpio0", "gpio1", "gpio2", "gpio3"; + function = "qspi_data"; + drive-strength = <8>; + bias-disable; + }; + }; +}; + +&qpic_bam { + status = "okay"; +}; + +&qpic_nand { + pinctrl-0 = <&qpic_snand_default_state>; + pinctrl-names = "default"; + status = "okay"; + + flash@0 { + compatible = "spi-nand"; + reg = <0>; + #address-cells = <1>; + #size-cells = <1>; + nand-ecc-engine = <&qpic_nand>; + nand-ecc-strength = <4>; + nand-ecc-step-size = <512>; + }; }; &usb_0_dwc3 { diff --git a/arch/arm64/boot/dts/qcom/ipq9574.dtsi b/arch/arm64/boot/dts/qcom/ipq9574.dtsi index 7f2e5cbf3bbb..786bb3540d6c 100644 --- a/arch/arm64/boot/dts/qcom/ipq9574.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq9574.dtsi @@ -319,6 +319,33 @@ tcsr: syscon@1937000 { reg = <0x01937000 0x21000>; }; + qpic_bam: dma-controller@7984000 { + compatible = "qcom,bam-v1.7.0"; + reg = <0x7984000 0x1c000>; + interrupts = <GIC_SPI 146 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&gcc GCC_QPIC_AHB_CLK>; + clock-names = "bam_clk"; + #dma-cells = <1>; + qcom,ee = <0>; + status = "disabled"; + }; + + qpic_nand: spi@79b0000 { + compatible = "qcom,spi-qpic-snand"; + reg = <0x79b0000 0x10000>; + #address-cells = <1>; + #size-cells = <0>; + clocks = <&gcc GCC_QPIC_CLK>, + <&gcc GCC_QPIC_AHB_CLK>, + <&gcc GCC_QPIC_IO_MACRO_CLK>; + clock-names = "core", "aon", "iom"; + dmas = <&qpic_bam 0>, + <&qpic_bam 1>, + <&qpic_bam 2>; + dma-names = "tx", "rx", "cmd"; + status = "disabled"; + }; + sdhc_1: mmc@7804000 { compatible = "qcom,ipq9574-sdhci", "qcom,sdhci-msm-v5"; reg = <0x07804000 0x1000>, -- 2.34.1