On Mon, May 06, 2024 at 09:57:07PM +0300, Andy Shevchenko wrote: > Mon, May 06, 2024 at 05:08:20PM +0200, Johan Hovold kirjoitti: > > Request and deassert any (optional) reset gpio during probe in case it > > has been left asserted by the boot firmware. > > > > Note the reset line is not asserted to avoid reverting to the default > > I2C address in case the firmware has configured an alternate address. > > ... > > > + reset = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW); > > + if (IS_ERR(reset)) > > + return PTR_ERR(reset); > > Shouldn't you wait a bit to make chip settle down? Yeah, probably. I actually asserted reset here for a while (e.g. to reset the address), but didn't have to use a post-reset delay then. I'll see if I can find someone with access to a datasheet or maybe add some small delay here anyway. Johan