From: Matt Ranostay <mranostay@xxxxxx> The board uses SERDES0 Lane 3 for USB3 IP. So update the SerDes lane info for USB. Add the pin mux data and enable USB3 support. Signed-off-by: Matt Ranostay <mranostay@xxxxxx> Signed-off-by: Ravi Gunasekaran <r-gunasekaran@xxxxxx> --- Changes since v2: ----------------- * No change Changes since v1: ---------------- * Fixed dtbs_check warning by renaming 'main-usbss0-pins-default' to 'main-usbss0-default-pins' v2: https://lore.kernel.org/all/20240506052044.8228-3-r-gunasekaran@xxxxxx/ v1: https://lore.kernel.org/all/20240502053615.29514-3-r-gunasekaran@xxxxxx/ arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 41 ++++++++++++++++++++++++ 1 file changed, 41 insertions(+) diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts index d511b25d62e3..a2d3cba0423e 100644 --- a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts +++ b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts @@ -336,6 +336,13 @@ J784S4_IOPAD(0x010, PIN_INPUT_PULLUP, 8) /* (AH33) MCAN13_RX.I2C4_SDA */ >; }; + + main_usbss0_pins_default: main-usbss0-default-pins { + bootph-all; + pinctrl-single,pins = < + J784S4_IOPAD(0x0ec, PIN_OUTPUT, 6) /* (AN37) TIMER_IO1.USB0_DRVVBUS */ + >; + }; }; &wkup_pmx2 { @@ -1041,6 +1048,40 @@ <&k3_clks 218 22>; }; +&serdes0 { + status = "okay"; + + serdes0_usb_link: phy@3 { + reg = <3>; + cdns,num-lanes = <1>; + #phy-cells = <0>; + cdns,phy-type = <PHY_TYPE_USB3>; + resets = <&serdes_wiz0 4>; + }; +}; + +&serdes_wiz0 { + status = "okay"; +}; + +&usb_serdes_mux { + idle-states = <0>; /* USB0 to SERDES lane 3 */ +}; + +&usbss0 { + status = "okay"; + pinctrl-0 = <&main_usbss0_pins_default>; + pinctrl-names = "default"; + ti,vbus-divider; +}; + +&usb0 { + dr_mode = "otg"; + maximum-speed = "super-speed"; + phys = <&serdes0_usb_link>; + phy-names = "cdns3,usb3-phy"; +}; + &serdes_wiz4 { status = "okay"; }; -- 2.17.1
