On 06/05/2024 13:33, Delphine CC Chiu wrote:
> Set I3C config in yosemite4 DTS.
>
> Test plan:
> Tested with aspeed I3C patches and I3C hub driver.
>
> Signed-off-by: Delphine CC Chiu <Delphine_CC_Chiu@xxxxxxxxxx>
> ---
> .../aspeed/aspeed-bmc-facebook-yosemite4.dts | 86 +++++++++++++++++++
> 1 file changed, 86 insertions(+)
>
> diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
> index 64075cc41d92..6a30c424d745 100644
> --- a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
> +++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
> @@ -595,6 +595,92 @@ i2c-mux@72 {
> };
> };
>
> +&i3c0 {
> + status = "okay";
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_i3c1_default>;
> + i3c-pp-scl-hi-period-ns = <40>;
> + i3c-pp-scl-lo-period-ns = <40>;
> + i3c-od-scl-hi-period-ns = <380>;
> + i3c-od-scl-lo-period-ns = <620>;
> + sda-tx-hold-ns = <10>;
> +
> + mctp-controller;
> + hub@0x70 {
That's not a valid unit address.
> + reg = <0x70 0x3c0 0x00700000>;
> + cp0-ldo-en = "enabled";
> + cp1-ldo-en = "enabled";
> + cp0-ldo-volt = "1.2V";
> + cp1-ldo-volt = "1.2V";
> + tp0145-ldo-en = "enabled";
> + tp2367-ldo-en = "enabled";
> + tp0145-ldo-volt = "1.2V";
> + tp2367-ldo-volt = "1.2V";
> + tp0145-pullup = "2k";
> + tp2367-pullup = "2k";
Where are bindings for all this?
Best regards,
Krzysztof
