From: Matt Ranostay <mranostay@xxxxxx>
The board uses SERDES0 Lane 3 for USB3 IP. So update the
SerDes lane info for USB. Add the pin mux data and
enable USB3 support.
Signed-off-by: Matt Ranostay <mranostay@xxxxxx>
Signed-off-by: Ravi Gunasekaran <r-gunasekaran@xxxxxx>
---
arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 41 ++++++++++++++++++++++++
1 file changed, 41 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
index d511b25d62e3..bee73dab803d 100644
--- a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
@@ -336,6 +336,13 @@
J784S4_IOPAD(0x010, PIN_INPUT_PULLUP, 8) /* (AH33) MCAN13_RX.I2C4_SDA */
>;
};
+
+ main_usbss0_pins_default: main-usbss0-pins-default {
+ bootph-all;
+ pinctrl-single,pins = <
+ J784S4_IOPAD(0x0ec, PIN_OUTPUT, 6) /* (AN37) TIMER_IO1.USB0_DRVVBUS */
+ >;
+ };
};
&wkup_pmx2 {
@@ -1041,6 +1048,40 @@
<&k3_clks 218 22>;
};
+&serdes0 {
+ status = "okay";
+
+ serdes0_usb_link: phy@3 {
+ reg = <3>;
+ cdns,num-lanes = <1>;
+ #phy-cells = <0>;
+ cdns,phy-type = <PHY_TYPE_USB3>;
+ resets = <&serdes_wiz0 4>;
+ };
+};
+
+&serdes_wiz0 {
+ status = "okay";
+};
+
+&usb_serdes_mux {
+ idle-states = <0>; /* USB0 to SERDES lane 3 */
+};
+
+&usbss0 {
+ status = "okay";
+ pinctrl-0 = <&main_usbss0_pins_default>;
+ pinctrl-names = "default";
+ ti,vbus-divider;
+};
+
+&usb0 {
+ dr_mode = "otg";
+ maximum-speed = "super-speed";
+ phys = <&serdes0_usb_link>;
+ phy-names = "cdns3,usb3-phy";
+};
+
&serdes_wiz4 {
status = "okay";
};
--
2.17.1
