Hello Krzysztof, thanks for your feedback, please see my answers below. On Mon, 2024-04-22 at 09:54 +0200, Krzysztof Kozlowski wrote: > On 22/04/2024 08:51, Christoph Fritz wrote: > > Add documentation of device tree bindings for serdev UART LIN-Bus > > devices equipped with LIN transceivers. > > A nit, subject: drop second/last, redundant "dt bindings". The > "dt-bindings" prefix is already stating that these are bindings. > See also: > https://elixir.bootlin.com/linux/v6.7-rc8/source/Documentation/devicetree/bindings/submitting-patches.rst#L18 OK > > > > > Signed-off-by: Christoph Fritz <christoph.fritz@xxxxxxxxx> > > --- > > .../bindings/net/can/linux,lin-serdev.yaml | 29 +++++++++++++++++++ > > 1 file changed, 29 insertions(+) > > create mode 100644 Documentation/devicetree/bindings/net/can/linux,lin-serdev.yaml > > > > diff --git a/Documentation/devicetree/bindings/net/can/linux,lin-serdev.yaml b/Documentation/devicetree/bindings/net/can/linux,lin-serdev.yaml > > new file mode 100644 > > index 0000000000000..cb4e932ff249c > > --- /dev/null > > +++ b/Documentation/devicetree/bindings/net/can/linux,lin-serdev.yaml > > @@ -0,0 +1,29 @@ > > +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) > > +%YAML 1.2 > > +--- > > +$id: http://devicetree.org/schemas/net/can/linux,lin-serdev.yaml# > > +$schema: http://devicetree.org/meta-schemas/core.yaml# > > + > > +title: Linux serdev LIN-Bus Support > > This looks like Linux binding, but we expect here description of hardware. OK > > + > > +description: | > > + LIN-Bus support for UART devices equipped with LIN transceivers, > > + utilizing the Serial Device Bus (serdev) interface. > > serdev is Linux thingy, AFAIR. Please describe the hardware. OK, in v2 it will get changed to: """ LIN transceiver, mostly hard-wired to a serial device, used for communication on a LIN bus. """ > > > + > > + For more details on an adapter, visit: https://hexdev.de/hexlin#tty > > + > > +properties: > > + compatible: > > + const: linux,lin-serdev > > Feels confusing. Your link describes real hardware, but you wrote > bindings for software construct. > > If you add this to DT, then it is hard-wired on the board, right? Yes, it is hard-wired. > If so, how this could be a software construct? It's not, but fairly generic, that's why I used 'linux,lin-serdev' as compatible string. In v2 I'll change it to 'hexdev,lin-serdev'. > > + > > +required: > > + - compatible > > + > > +examples: > > + - | > > + &uart2 { > > & does not make much sense here. I think you wanted it to be serial bus, > so serial. OK > > > + status = "okay"; > > Drop, it was not disabled anywhere. OK > > > > + linbus { > > + compatible = "linux,lin-serdev"; > > + }; > > + }; Let me address these points, fix warnings from dt_binding_check and reroll in v2. Thanks -- Christoph