[PATCH v7 0/5] Add support for MAX96714/F and MAX96717/F GMSL2 ser/des

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Change since v6:
  - Remove mention of C-PHY for MAX96717, this serializer is D-PHY only
  - Remove bus-type requirement for MAX96717
  - Minor changes requested by Sakari
  - Workaround a MAX96717 issue, which occurs when stopping
    the CSI source before stopping the MAX96717 CSI receiver.

Power management is not included in this patchset. The GMSL link is
not always resuming when the deserializer is suspended without
suspending the serializer.

Change since v5:
 - Reverse fallback logic: max9671{4,7} can fallback to max9671{4,7}F
 - use const instead of enum for max9671{4,7}f compatible as suggested

Change since v4:
 - Add support for MAX96717 and MAX96714 and use them as a fallback for
   MAX96717F and MAX96714F respectively
 - The drivers are now compatible with MAX96717 and MAX96714 since no change in
   the logic is needed
 - Reference 'i2c-gate' instead of 'i2c-controller' in the bindings

Change since v3:
- bindings
  - Renamed bindings to drop the 'f' suffix
  - Add bus type to MAX96717 and remove from MAX9674
  - Add lane-polarities to both bindings

- drivers
  - Address changes requested by Sakari in v3
  - use v4l2_subdev_s_stream_helper for MAX96714
  - do not init regmap twice in the MAX96714 driver
  - Fix compilations on 32 bits platforms

Change since v2:
- Convert drivers to use CCI helpers
- Use generic node name
- Use 'powerdown' as gpio name instead of 'enable'
- Add pattern generator support for MAX96714

These patches add support for Maxim MAX96714F deserializer and
MAX96717F serializer.

MAX96714F has one GMSL2 input port and one CSI2 4 lanes output port,
MAX96717F has one CSI2 input port and one GMSL2 output port.

The drivers support the tunnel mode where all the
CSI2 traffic coming from an imager is replicated through the deserializer
output port.

Both MAX96714F and MAX96717F are limited to a 3Gbps forward link rate
leaving a maximum of 2.6Gbps for the video payload.

Julien Massot (9):
  dt-bindings: media: add Maxim MAX96717 GMSL2 Serializer
  dt-bindings: media: add Maxim MAX96714 GMSL2 Deserializer
  media: i2c: add MAX96717 driver
  media: i2c: add MAX96714 driver
  drivers: media: max96717: stop the csi receiver before the source

 .../bindings/media/i2c/maxim,max96714.yaml    |  174 +++
 .../bindings/media/i2c/maxim,max96717.yaml    |  157 +++
 MAINTAINERS                                   |   14 +
 drivers/media/i2c/Kconfig                     |   34 +
 drivers/media/i2c/Makefile                    |    2 +
 drivers/media/i2c/max96714.c                  | 1024 +++++++++++++++++
 drivers/media/i2c/max96717.c                  |  927 +++++++++++++++
 7 files changed, 2332 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/maxim,max96714.yaml
 create mode 100644 Documentation/devicetree/bindings/media/i2c/maxim,max96717.yaml
 create mode 100644 drivers/media/i2c/max96714.c
 create mode 100644 drivers/media/i2c/max96717.c

-- 
2.44.0





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux