Hi On Fri, Apr 26, 2024 at 5:56 PM Fabio Estevam <festevam@xxxxxxxxx> wrote: > > Hi Fabio, > > On Fri, Apr 26, 2024 at 12:31 PM Fabio Aiuto <fabio.aiuto@xxxxxxxxxxx> wrote: > > > +&usdhc3 { /* WiFi */ > > + #address-cells = <1>; > > + #size-cells = <0>; > > + pinctrl-names = "default", "state_100mhz", "state_200mhz"; > > + pinctrl-0 = <&pinctrl_usdhc3>; > > + pinctrl-1 = <&pinctrl_usdhc3>; > > + pinctrl-2 = <&pinctrl_usdhc3>; > > + mmc-pwrseq = <&usdhc3_pwrseq>; > > + bus-width = <4>; > > + no-1-8-v; > > + non-removable; > > + max-frequency = <25000000>; > > Is this 25MHz limitation correct? This make the wifi a bit slow ;). You should be able to go to ~50Mhz at 3.3v. BTW the other mux are not needed "state_100mhz", "state_200mhz"; Sorry both Fabio, I did not see before Michael Michael -- Michael Nazzareno Trimarchi Co-Founder & Chief Executive Officer M. +39 347 913 2170 michael@xxxxxxxxxxxxxxxxxxxx __________________________________ Amarula Solutions BV Joop Geesinkweg 125, 1114 AB, Amsterdam, NL T. +31 (0)85 111 9172 info@xxxxxxxxxxxxxxxxxxxx www.amarulasolutions.com