Add another mux option for MCAN1 pins, this is used on
DH electronics STM32MP13xx DHCOR DHSBC board.
Signed-off-by: Marek Vasut <marex@xxxxxxx>
---
Cc: "Leonard Göhrs" <l.goehrs@xxxxxxxxxxxxxx>
Cc: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx>
Cc: Alexandre Torgue <alexandre.torgue@xxxxxxxxxxx>
Cc: Andre Przywara <andre.przywara@xxxxxxx>
Cc: Conor Dooley <conor+dt@xxxxxxxxxx>
Cc: Dario Binacchi <dario.binacchi@xxxxxxxxxxxxxxxxxxxx>
Cc: Krzysztof Kozlowski <krzk+dt@xxxxxxxxxx>
Cc: Linus Walleij <linus.walleij@xxxxxxxxxx>
Cc: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
Cc: Rob Herring <robh@xxxxxxxxxx>
Cc: Sean Nyekjaer <sean@xxxxxxxxxx>
Cc: Steffen Trumtrar <s.trumtrar@xxxxxxxxxxxxxx>
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: kernel@xxxxxxxxxxxxxxxxxx
Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
Cc: linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
---
arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi b/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi
index cfbae71efc729..b38174504fffa 100644
--- a/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi
+++ b/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi
@@ -168,6 +168,26 @@ pins {
};
};
+ m_can1_pins_a: m-can1-0 {
+ pins1 {
+ pinmux = <STM32_PINMUX('G', 10, AF9)>; /* CAN1_TX */
+ slew-rate = <1>;
+ drive-push-pull;
+ bias-disable;
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('D', 0, AF9)>; /* CAN1_RX */
+ bias-disable;
+ };
+ };
+
+ m_can1_sleep_pins_a: m_can1-sleep-0 {
+ pins {
+ pinmux = <STM32_PINMUX('G', 10, ANALOG)>, /* CAN1_TX */
+ <STM32_PINMUX('D', 0, ANALOG)>; /* CAN1_RX */
+ };
+ };
+
mcp23017_pins_a: mcp23017-0 {
pins {
pinmux = <STM32_PINMUX('G', 12, GPIO)>;
--
2.43.0
