The RG35XX-Plus adds a RTL8221CS SDIO Wifi/BT chip to the RG35XX (2024). Enabled in this DTS: - WiFi - Bluetooth - Supporting power sequence and GPIOs Changelog v1..v2: - Update copyright - Spaces -> Tabs - Remove redundant &uart0 node and DTS version tag - Add GPIO bank comments - Use generic pwrseq name Signed-off-by: Ryan Walklin <ryan@xxxxxxxxxxxxx> --- .../sun50i-h700-anbernic-rg35xx-plus.dts | 53 +++++++++++++++++++ 1 file changed, 53 insertions(+) create mode 100644 arch/arm64/boot/dts/allwinner/sun50i-h700-anbernic-rg35xx-plus.dts diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h700-anbernic-rg35xx-plus.dts b/arch/arm64/boot/dts/allwinner/sun50i-h700-anbernic-rg35xx-plus.dts new file mode 100644 index 000000000000..67ba1c7bb3ca --- /dev/null +++ b/arch/arm64/boot/dts/allwinner/sun50i-h700-anbernic-rg35xx-plus.dts @@ -0,0 +1,53 @@ +// SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +/* + * Copyright (C) 2024 Ryan Walklin <ryan@xxxxxxxxxxxxx>. + */ + +#include "sun50i-h700-anbernic-rg35xx-2024.dts" + +/ { + model = "Anbernic RG35XX Plus"; + compatible = "anbernic,rg35xx-plus", "allwinner,sun50i-h700"; + + wifi_pwrseq: pwrseq { + compatible = "mmc-pwrseq-simple"; + clocks = <&rtc CLK_OSC32K_FANOUT>; + clock-names = "ext_clock"; + pinctrl-0 = <&x32clk_fanout_pin>; + pinctrl-names = "default"; + post-power-on-delay-ms = <200>; + reset-gpios = <&pio 6 18 GPIO_ACTIVE_LOW>; /* PG18 */ + }; +}; + +/* SDIO WiFi RTL8821CS */ +&mmc1 { + vmmc-supply = <®_cldo4>; + vqmmc-supply = <®_pll_dcx0>; + mmc-pwrseq = <&wifi_pwrseq>; + bus-width = <4>; + non-removable; + status = "okay"; + + sdio_wifi: wifi@1 { + reg = <1>; + interrupt-parent = <&pio>; + interrupts = <6 15 IRQ_TYPE_LEVEL_LOW>; /* PG15 */ + interrupt-names = "host-wake"; + }; +}; + +/* Bluetooth RTL8821CS */ +&uart1 { + pinctrl-names = "default"; + pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>; + uart-has-rtscts; + status = "okay"; + + bluetooth { + compatible = "realtek,rtl8821cs-bt", "realtek,rtl8723bs-bt"; + device-wake-gpios = <&pio 6 17 GPIO_ACTIVE_HIGH>; /* PG17 */ + enable-gpios = <&pio 6 19 GPIO_ACTIVE_HIGH>; /* PG19 */ + host-wake-gpios = <&pio 6 16 GPIO_ACTIVE_HIGH>; /* PG16 */ + }; +}; -- 2.44.0