On Mon, Apr 01, 2024 at 04:10:49PM +0200, Krzysztof Kozlowski wrote: > Top-level nodes, not being on MMIO bus, do not have "reg" properties and > should not have unit addresses. Correct their name as well to match > "Generic node names" recommendation from Devicetree specification. > This also fixes dtc W=1 warnings: > > cn9130-db.dtsi:28.11-31.4: Warning (unique_unit_address_if_enabled): /memory@0: duplicate unit-address (also used in node /ap0_sd_vccq@0) > cn9130-db.dtsi:28.11-31.4: Warning (unique_unit_address_if_enabled): /memory@0: duplicate unit-address (also used in node /cp0_usb3_vbus@0) > cn9130-db.dtsi:33.33-40.4: Warning (unique_unit_address_if_enabled): /ap0_sd_vccq@0: duplicate unit-address (also used in node /cp0_usb3_vbus@0) > cn9130-db.dtsi:28.11-31.4: Warning (unique_unit_address_if_enabled): /memory@0: duplicate unit-address (also used in node /cp0_usb3_phy@0) > cn9130-db.dtsi:33.33-40.4: Warning (unit_address_vs_reg): /ap0_sd_vccq@0: node has a unit name, but no reg or ranges property > cn9130-db.dtsi:42.38-49.4: Warning (unit_address_vs_reg): /cp0_usb3_vbus@0: node has a unit name, but no reg or ranges property > cn9130-db.dtsi:51.34-54.4: Warning (unit_address_vs_reg): /cp0_usb3_phy@0: node has a unit name, but no reg or ranges property > cn9130-db.dtsi:56.38-63.4: Warning (unit_address_vs_reg): /cp0_usb3_vbus@1: node has a unit name, but no reg or ranges property > > Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx> Reviewed-by: Andrew Lunn <andrew@xxxxxxx> Andrew