On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge for each controller instance. Hence, add a node to represent the bridge. Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> --- arch/arm64/boot/dts/qcom/ipq8074.dtsi | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/ipq8074.dtsi b/arch/arm64/boot/dts/qcom/ipq8074.dtsi index e5b89753aa5c..12324841d1b0 100644 --- a/arch/arm64/boot/dts/qcom/ipq8074.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq8074.dtsi @@ -864,6 +864,16 @@ IRQ_TYPE_LEVEL_HIGH>, /* int_c */ "ahb", "axi_m_sticky"; status = "disabled"; + + pcie@0 { + device_type = "pci"; + reg = <0x0 0x0 0x0 0x0 0x0>; + bus-range = <0x01 0xff>; + + #address-cells = <3>; + #size-cells = <2>; + ranges; + }; }; pcie0: pcie@20000000 { @@ -929,6 +939,16 @@ IRQ_TYPE_LEVEL_HIGH>, /* int_c */ "axi_m_sticky", "axi_s_sticky"; status = "disabled"; + + pcie@0 { + device_type = "pci"; + reg = <0x0 0x0 0x0 0x0 0x0>; + bus-range = <0x01 0xff>; + + #address-cells = <3>; + #size-cells = <2>; + ranges; + }; }; }; -- 2.25.1