On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom/qcom-ipq4019.dtsi | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/arch/arm/boot/dts/qcom/qcom-ipq4019.dtsi b/arch/arm/boot/dts/qcom/qcom-ipq4019.dtsi
index 681cb3fc8085..f09c123d9fa2 100644
--- a/arch/arm/boot/dts/qcom/qcom-ipq4019.dtsi
+++ b/arch/arm/boot/dts/qcom/qcom-ipq4019.dtsi
@@ -470,6 +470,16 @@ pcie0: pcie@40000000 {
"phy_ahb";
status = "disabled";
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
qpic_bam: dma-controller@7984000 {
--
2.25.1
