On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge for each controller instance. Hence, add a node to represent the bridge. Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> --- arch/arm/boot/dts/qcom/qcom-sdx55.dtsi | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi b/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi index edc9aaf828c8..68fa5859d263 100644 --- a/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi +++ b/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi @@ -378,6 +378,16 @@ pcie_rc: pcie@1c00000 { phy-names = "pciephy"; status = "disabled"; + + pcie@0 { + device_type = "pci"; + reg = <0x0 0x0 0x0 0x0 0x0>; + bus-range = <0x01 0xff>; + + #address-cells = <3>; + #size-cells = <2>; + ranges; + }; }; pcie_ep: pcie-ep@1c00000 { -- 2.25.1