Re: [PATCH v4 1/5] dt-bindings: misc: Add mikrobus-connector

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Andrew,

On 19/03/24 17:55, Andrew Lunn wrote:
The device tree defines the SPI controller associated with mikroBUS SPI
pins. The driver on match queries and takes a reference to the SPI
controller but does nothing with it. Once a mikroBUS add-on board is
detected (by passing manifest using sysfs or reading from 1-wire EEPROM),
the driver parses the manifest, and if it detects an SPI device in manifest,
it registers SPI device along with setting properties such as `chip_select`,
`max_speed_hz`, `mode`, etc.,

How complex can the description of the hardware be in the manifest?

Could i describe an SPI to I2C converter? And then a few temperature
sensors, a fan controller, and a GPIO controller on that I2C bus? And
the GPIO controller is then used for LEDs and a push button? DT
overlays could describe that. Can the manifest?

No, it cannot describe such complex hardware, it can only describe simple devices (sensors/displays .etc) on a standard mikroBUS add-on board, we did a analysis on what mikroBUS add-on boards have driver support in Linux and then noticed that most devices does not need this kind of complex description to work:
https://elinux.org/MikroEClicks_with_Linux_Support

The greybus manifest already is being used in the greybus susbystem for describing an interface and there are already greybus controllers (SPI/I2C .etc) being created according to the manifest contents, all this driver does is to extend that format to be able to instantiate devices on these buses. The primary goals for introducing the driver for mikroBUS add-on boards are:

1) A way to isolate platform specific information from add-on board specific information - so that each permutation of connecting the add-on board on different ports on different board does not require a new overlay. 2) A way to instantiate add-on boards on greybus created virtual mikroBUS ports.
3) Both 1 and 2 should use the same add-on board description format.

Standard device tree overlays did not help to achieve this and that is why the standard interface discovery mechanism in greybus, the manifest was extended even though it is not the most optimal way to describe hardware.

The greybus manifest extensions were made with the following things in mind and three new descriptor were introduced:
1) mikrobus descriptor - pinmux/port state
2) device descriptor - contains information which is a superset of struct i2c_board_info , struct spi_board_info .etc 3) property descriptor - to describe named properties of the types defined under https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/include/linux/property.h#n22

With these we were able to test around 150 add-on boards with corresponding drivers in Linux : https://github.com/MikroElektronika/click_id/tree/main/manifests

The mechanism is not as robust a device tree and should not be compared, the intent was not to create a new hardware description format, but extend the existing greybus manifest format to be able to instantiate devices on the greybus SPI/I2C/GPIO/ (mikroBUS)

Thanks and Regards,
Vaishnav



	Andrew




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux