This patchset adds mipi dphy tx support for the StarFive JH7110 SoC. It is used to transfer DSI data. The series has been tested on the VisionFive 2 board. change since v3: - Rebased on tag v6.8-rc6. patch 2: - Lower case for hex value. - Replace bit shifts operation with macro definitions. - Drop delay in stf_dphy_hw_reset(). - Change variable declarations order in stf_dphy_configure(). v3: https://patchwork.kernel.org/project/linux-phy/cover/20240206061921.107372-1-shengyang.chen@xxxxxxxxxxxxxxxx/ change since v2: - Rebased on tag v6.8-rc3. patch 2: - Drop regulator operation. v2: https://patchwork.kernel.org/project/linux-phy/cover/20240109071246.24065-1-shengyang.chen@xxxxxxxxxxxxxxxx/ changes since v1: - Rebased on tag v6.7. patch 1: - Drop 'dphy_'prefix. - Drop DSI reset. - Drop unnecessary resets. patch 2: - Changed the commit message. - Use dev_err_probe() and PTR_ERR() in probing. - Drop DSI reset operation. - Drop unnecessary resets operation. - Add configs in array for full support of the module - Changed 'void *io_addr' to 'void __iomem *io_addr'. v1: https://patchwork.kernel.org/project/linux-phy/cover/20231117130421.79261-1-shengyang.chen@xxxxxxxxxxxxxxxx/ Shengyang Chen (2): dt-bindings: phy: Add starfive,jh7110-dphy-tx phy: starfive: Add mipi dphy tx support .../bindings/phy/starfive,jh7110-dphy-tx.yaml | 68 ++ MAINTAINERS | 7 + drivers/phy/starfive/Kconfig | 10 + drivers/phy/starfive/Makefile | 1 + drivers/phy/starfive/phy-jh7110-dphy-tx.c | 702 ++++++++++++++++++ 5 files changed, 788 insertions(+) create mode 100644 Documentation/devicetree/bindings/phy/starfive,jh7110-dphy-tx.yaml create mode 100644 drivers/phy/starfive/phy-jh7110-dphy-tx.c -- 2.17.1
