On 21/02/2024 11:34, Md Sadre Alam wrote: > > > On 2/20/2024 5:06 PM, Krzysztof Kozlowski wrote: >> On 20/02/2024 12:32, Md Sadre Alam wrote: >>> >>> >>> On 2/19/2024 6:34 PM, Manivannan Sadhasivam wrote: >>>> On Thu, Feb 15, 2024 at 07:18:51PM +0530, Md Sadre Alam wrote: >>>>> This series of patches will add initial supports >>>>> for QPIC SPI NAND driver. >>>>> >>>>> Currently this driver support following commands >>>>> >>>>> -- RESET >>>>> -- READ ID >>>>> -- BLOCK ERASE >>>>> -- PAGE READ >>>>> -- PAGE WRITE >>>>> -- GET FEATURE >>>>> -- SET FEATURE >>>>> -- BAD BLOCK CHECK >>>>> >>>>> This driver has been tested with dd command with read/write page >>>>> with multiple file size 1MiB, 10MiB,40MiB etc. >>>>> Also tested with "mtd" command like mtd erase, mtd write, mtd verify etc. >>>>> >>>> >>>> This is not the first version isn't it? Where is the changelog describing what >>>> has changed since then? >>> >>> The earlier patch was the RFC for design review only. >> >> RFC is state of patch, not version. This is v2 then. >> >> These RFC postings are really becoming mess. Some people make multiple >> RFCs and then post v1 hiding entire previous history... And why even >> bother with calling it RFC? > > Sorry, I was not aware of this. Shall I post the next one as V3 > and add references to the RFC patch and this patch in the cover > letter of V3? Yes, like with every posting. Best regards, Krzysztof