On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge for each controller instance. Hence, add a node to represent the bridge. Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> --- arch/arm/boot/dts/qcom/qcom-apq8064.dtsi | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi b/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi index 3faf57035d54..1ebd6cef4057 100644 --- a/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi +++ b/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi @@ -1318,6 +1318,16 @@ pcie: pcie@1b500000 { <&gcc PCIE_PHY_RESET>; reset-names = "axi", "ahb", "por", "pci", "phy"; status = "disabled"; + + pcie@0 { + device_type = "pci"; + reg = <0x0 0x0 0x0 0x0 0x0>; + bus-range = <0x01 0xff>; + + #address-cells = <3>; + #size-cells = <2>; + ranges; + }; }; hdmi: hdmi-tx@4a00000 { -- 2.25.1