This change does not have any functional effect. The switch works just fine without this patch as it has full access to all the addresses on the bus. This is simply a clean-up to set the node name address and reg address to the same value. Fixes: 15b43e497ffd ("ARM: dts: imx6dl-yapp4: Use correct pseudo PHY address for the switch") Signed-off-by: Michal Vokáč <michal.vokac@xxxxxxxxx> --- changes in v2: - Reword the commit message so it is clear that this patch does not fix a functional problem. arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi b/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi index cfb0fc924b42..5763f8253d51 100644 --- a/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi +++ b/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi @@ -143,7 +143,7 @@ switch@10 { compatible = "qca,qca8334"; - reg = <10>; + reg = <0x10>; reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>; switch_ports: ports { -- 2.1.4