This should have been a v2, please ignore this . I will resend.
Thanks
On 12/02/24 3:29 pm, Bhavya Kapoor wrote:
WKUP_PADCONFIG registers for wkup_uart0 and mcu_uart0 lies under
wkup_pmx2 for J7200. Thus, modify pinmux for both of them. Also,
remove the redundant clock-frequency property from mcu_uart0 node.
Only Tx and Rx Signal lines for wkup_uart0 are brought out on
J721S2 Common Proc Board and J784S4 EVM, but CTS and RTS signal lines
are not brought out. Thus, remove pinmux for CTS and RTS signal lines
for wkup_uart0 in J721S2 and J784S4.
Bhavya Kapoor (4):
arm64: dts: ti: k3-j7200-common-proc-board: Modify Pinmux for
wkup_uart0 and mcu_uart0
arm64: dts: ti: k3-j7200-common-proc-board: Remove clock-frequency
from mcu_uart0
arm64: dts: ti: k3-j721s2-common-proc-board: Remove Pinmux for CTS and
RTS in wkup_uart0
arm64: dts: ti: k3-j784s4-evm: Remove Pinmux for CTS and RTS in
wkup_uart0
.../boot/dts/ti/k3-j7200-common-proc-board.dts | 18 +++++++++---------
.../dts/ti/k3-j721s2-common-proc-board.dts | 2 --
arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 --
3 files changed, 9 insertions(+), 13 deletions(-)
