Re: [PATCH v2 5/6] drm/panel: st7703: Drive XBD599 panel at higher clock rate

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Frank,

On Mon, Feb 05, 2024 at 04:22:28PM +0100, Frank Oltmanns wrote:
> This panel is used in the pinephone that runs on a Allwinner A64 SOC.
> The SOC requires pll-mipi to run at more than 500 MHz.
> 
> This is the relevant clock tree:
>  pll-mipi
>     tcon0
>        tcon-data-clock
> 
> tcon-data-clock has to run at 1/4 the DSI per-lane bit rate. The XBD599
> has 24 bpp and 4 lanes. Therefore, the resulting requested
> tcon-data-clock rate is:
>     crtc_clock * 1000 * (24 / 4) / 4
> 
> tcon-data-clock runs at tcon0 / 4 (fixed divisor), so it requests a
> parent rate of
>     4 * (crtc_clock * 1000 * (24 / 4) / 4)
> 
> Since tcon0 is a ccu_mux, the rate of tcon0 equals the rate of pll-mipi.
> 
> pll-mipi's constraint to run at 500MHz or higher forces us to have a
> crtc_clock >= 83333 kHz if we want a 60 Hz vertical refresh rate.
> 
> Change [hv]sync_(start|end) so that we reach a clock rate of 83502 kHz
> so that it is high enough to align with pll-pipi limits.
> 
> Signed-off-by: Frank Oltmanns <frank@xxxxxxxxxxxx>

That commit log is great, but it's kind of off-topic. It's a panel
driver, it can be used on any MIPI-DSI controller, the only relevant
information there should be the panel timings required in the datasheet.

The PLL setup is something for the MIPI-DSI driver to adjust, not for
the panel to care for.

Maxime

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux