Hi, Mihai,
On 23.01.2024 11:07, Mihai.Sain@xxxxxxxxxxxxx wrote:
> Hi Krzysztof,
>
> I'm sorry for quoting (email is sent from Outlook).
> The sdmmc controller from SAM9 MPUs doesn't support the IO voltage signaling/switching required by the UHS sd-card.
> On the electrical schematics of the boards the controller and sd-card power pins are connected to 3V3 regulator.
> On the SAMA5 MPUs there is support for IO voltage switching but since we have issues with the tuning procedure required but the UHS cards,
> we want to keep vqmmc at 3V3 in order to use high-speed mode.
Can you capture this information in each patch description?
>
> Best regards,
> Mihai Sain
>
> ----------------------------------------------------------------------
>
>> diff --git a/arch/arm/boot/dts/microchip/at91-sam9x60_curiosity.dts
>> b/arch/arm/boot/dts/microchip/at91-sam9x60_curiosity.dts
>> index c6fbdd29019f..457c54dde0b7 100644
>> --- a/arch/arm/boot/dts/microchip/at91-sam9x60_curiosity.dts
>> +++ b/arch/arm/boot/dts/microchip/at91-sam9x60_curiosity.dts
>> @@ -452,6 +452,8 @@ &sdmmc0 {
>> pinctrl-0 = <&pinctrl_sdmmc0_default &pinctrl_sdmmc0_cd>;
>> cd-gpios = <&pioA 25 GPIO_ACTIVE_LOW>;
>> disable-wp;
>> + vmmc-supply = <&vdd1_3v3>;
>> + vqmmc-supply = <&vdd1_3v3>;
>
> For this and all other patches:
>
> It is surprising that you use the same supply for both. Looks like inaccurate description. It is possible, but I think unlikely because usually VQMMC has lower voltage than 3.3V.
>
> Best regards,
> Krzysztof
>
