On Tue, 2015-01-27 at 12:57AM +0100, Andreas Färber wrote: > Am 09.01.2015 um 16:43 schrieb Soren Brinkmann: > > Add pinctrl descriptions to the zc702 and zc706 device trees. > > > > Signed-off-by: Soren Brinkmann <soren.brinkmann@xxxxxxxxxx> > > Tested-by: Andreas Färber <afaerber@xxxxxxx> > > --- > > Changes since v1: > > - remove 'pinctrl-' prefix for pinctrl sub-nodes > > - separate config and mux nodes > > > > Changes since RFC v2: > > - add pinconf properties to zc702 mdio node > > - remove arguments from bias-related props > > > > Changes since RFC v1: > > - separate DT changes into their own patch > > --- > > arch/arm/boot/dts/zynq-7000.dtsi | 8 +- > > arch/arm/boot/dts/zynq-zc702.dts | 181 +++++++++++++++++++++++++++++++++++++++ > > arch/arm/boot/dts/zynq-zc706.dts | 152 ++++++++++++++++++++++++++++++++ > > 3 files changed, 340 insertions(+), 1 deletion(-) > [...] > > diff --git a/arch/arm/boot/dts/zynq-zc702.dts b/arch/arm/boot/dts/zynq-zc702.dts > > index 280f02dd4ddc..4995412f116f 100644 > > --- a/arch/arm/boot/dts/zynq-zc702.dts > > +++ b/arch/arm/boot/dts/zynq-zc702.dts > [...] > > @@ -50,15 +52,24 @@ > > status = "okay"; > > phy-mode = "rgmii-id"; > > phy-handle = <ðernet_phy>; > > + pinctrl-names = "default"; > > + pinctrl-0 = <&pinctrl_gem0_default>; > > > > ethernet_phy: ethernet-phy@7 { > > reg = <7>; > > }; > > }; > > > > +&gpio0 { > > + pinctrl-names = "default"; > > + pinctrl-0 = <&pinctrl_gpio0_default>; > > On linux-next the equivalent no longer works for the Parallella, with > gpio failing to probe. > > If I move these two properties to the leds node (for which I am > configuring gpio 7) then I get a heartbeat as before. Moving this away from the gpio node seems wrong. IMHO, it should be where it is. I guess, there might be some issues with probe ordering/deferral that we may have to sort out. Sören -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html