CSI cameras are controlled using I2C. On J721S2 Common Processor Board,
this is routed to I2C-5, so enable the instance and the TCA6408
GPIO expander on the bus.
Signed-off-by: Vaishnav Achath <vaishnav.a@xxxxxx>
---
.../dts/ti/k3-j721s2-common-proc-board.dts | 25 +++++++++++++++++++
1 file changed, 25 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
index c6b85bbf9a17..3667aa179306 100644
--- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
@@ -147,6 +147,13 @@ J721S2_IOPAD(0x060, PIN_INPUT_PULLUP, 13) /* (AC27) MCASP2_AXR1.I2C3_SDA */
>;
};
+ main_i2c5_pins_default: main-i2c5-default-pins {
+ pinctrl-single,pins = <
+ J721S2_IOPAD(0x01c, PIN_INPUT, 8) /* (Y24) MCAN15_TX.I2C5_SCL */
+ J721S2_IOPAD(0x018, PIN_INPUT, 8) /* (W23) MCAN14_RX.I2C5_SDA */
+ >;
+ };
+
main_mmc1_pins_default: main-mmc1-default-pins {
pinctrl-single,pins = <
J721S2_IOPAD(0x104, PIN_INPUT, 0) /* (P23) MMC1_CLK */
@@ -356,6 +363,24 @@ exp2: gpio@22 {
};
};
+&main_i2c5 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_i2c5_pins_default>;
+ clock-frequency = <400000>;
+ status = "okay";
+
+ exp5: gpio@20 {
+ compatible = "ti,tca6408";
+ reg = <0x20>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ gpio-line-names = "CSI2_EXP_RSTZ", "CSI2_EXP_A_GPIO0",
+ "CSI2_EXP_A_GPIO1", "CSI2_EXP_A_GPIO2",
+ "CSI2_EXP_B_GPIO1", "CSI2_EXP_B_GPIO2",
+ "CSI2_EXP_B_GPIO3", "CSI2_EXP_B_GPIO4";
+ };
+};
+
&main_sdhci0 {
/* eMMC */
status = "okay";
--
2.34.1
