Add reference to rs485.yaml. Add rs485 support to uartps driver. --- Changes for V2: Modify optional gpio name to xlnx,phy-ctrl-gpios. Update commit description. Add support for RTS, delay_rts_before_send and delay_rts_after_send in RS485 mode. Changes for V3: Modify optional gpio name to rts-gpios. Update commit description. Move cdns_uart_tx_empty function to avoid prototype statement. Remove assignment of struct serial_rs485 to port->rs485 as serial core performs that. Switch to native RTS in non GPIO case. Handle rs485 during stop tx. Remove explicit calls to configure gpio direction and value, as devm_gpiod_get_optional performs that by using GPIOD_OUT_LOW argument. Update implementation to support configuration of GPIO/RTS value based on user configuration of SER_RS485_RTS_ON_SEND and SER_RS485_RTS_AFTER_SEND. Move implementation to start_tx from handle_tx. Changes for V4: Update rts-gpios description. Create separate patch for cdns_uart_tx_empty relocation. Call cdns_rs485_rx_setup() before uart_add_one_port() in probe. Update gpio descriptor name to gpiod_rts. Instead of cdns_rs485_config_gpio_rts_high() and cdns_rs485_config_gpio_rts_low() functions for RTS/GPIO value configuration implement cdns_rts_gpio_enable(). Disable auto rts and call cdns_uart_stop_tx() from cdns_rs485_config. Use timer instead of mdelay for delay_rts_before_send and delay_rts_after_send. Update cdns_uart_set_mctrl to support GPIO/RTS. Changes for V5: Remove rts-gpios description. Update commit message and description. Changes for V6: Update commit description. Disable the TX and RX in cdns_rs485_config() when rs485 disabled. Hold lock for cdns_uart_handle_tx() in cdns_rs485_tx_callback(). Changes for V7: Update commit description. Changes for V8: Use hrtimer instead of timer list. Simplify cdns_rs485_tx_setup() and cdns_rs485_rx_setup(). Update argument of cdns_rts_gpio_enable() in cdns_uart_set_mctrl(). Add cdns_calc_after_tx_delay() to calculate required delay after tx. Add hrtimer setup in cdns_rs485_config(). Move enable TX Empty interrupt and rs485 rx callback scheduling part to cdns_uart_handle_tx(). Changes for V9: Update return check with uart_tx_stopped() in cdns_uart_handle_tx(). Update description of cdns_uart_handle_tx() and add clear TX Empty interrupt comment cdns_uart_start_tx(). Remove stop tx timer. Remove hrtimer_cancel() call from cdns_uart_start_tx(). Handle gpio case separately in cdns_uart_set_mctrl(). Move hrtimer_cancel() call from below to above in cdns_uart_shutdown(). Changes for V10: Add disable the TX Empty interrupt comment in cdns_uart_handle_tx(). Manikanta Guntupalli (3): dt-bindings: Add reference to rs485.yaml tty: serial: uartps: Relocate cdns_uart_tx_empty to facilitate rs485 tty: serial: uartps: Add rs485 support to uartps driver .../devicetree/bindings/serial/cdns,uart.yaml | 1 + drivers/tty/serial/xilinx_uartps.c | 236 ++++++++++++++++-- 2 files changed, 216 insertions(+), 21 deletions(-) -- 2.25.1
