On 1/18/2024 10:06 AM, hui liu wrote:
On 1/17/2024 11:41 AM, Dmitry Baryshkov wrote:
On Wed, 17 Jan 2024 at 05:02, hui liu <quic_huliu@xxxxxxxxxxx> wrote:
On 1/15/2024 6:26 PM, Krzysztof Kozlowski wrote:
On 15/01/2024 11:18, hui liu wrote:
On 1/15/2024 5:56 PM, Dmitry Baryshkov wrote:
On Mon, 15 Jan 2024 at 11:48, Hui Liu via B4 Relay
<devnull+quic_huliu.quicinc.com@xxxxxxxxxx> wrote:
From: Hui Liu <quic_huliu@xxxxxxxxxxx>
Add definition for three LEDs to make sure they can
be enabled base on QCOM LPG LED driver.
The "function" property is still placed incorrectly. Posting the next
iteration before concluding the discussion on the previous one is not
the best idea.
Do you mean I should update it as below? Seems there is no consumer to
use the function config, do we need to add now?
Paste the output of dtbs_check for your board (or CHECK_DTBS=y for your
Makefile target).
I checked the dt-binding file of LPG LED, I will update the dts as
below, if you think it's correct, I will push v6.
Is there any reason why you are defining three different LEDs instead
of multi-led with three components?
Hi Dmitry,
If there is no other issue, can I push the V6?
Thanks,
Hui
In the HW design, they are three seprete LEDs, there are three LEDs on
device. why do we need to add for multi-led?
Thanks,
Hui
+&pm8350c_pwm {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ status = "okay";
+
+ led@1 {
+ reg = <1>;
+ color = <LED_COLOR_ID_RED>;
+ function = LED_FUNCTION_STATUS;
+ };
+
+ led@2 {
+ reg = <2>;
+ color = <LED_COLOR_ID_GREEN>;
+ function = LED_FUNCTION_STATUS;
+ };
+
+ led@3 {
+ reg = <3>;
+ color = <LED_COLOR_ID_BLUE>;
+ function = LED_FUNCTION_STATUS;
+ };
+};
