This small series add LEDs support for qca808x. QCA808x apply on PHY reset a strange polarity settings and require some tweak to apply a more common configuration found on devices. On adding support for it, it was pointed out that a similar feature is also being implemented for a marvell PHY where LED polarity is set per LED (and not global) and also have a special mode where the LED is tristated. The first 3 patch are to generalize this as we expect more PHY in the future to have a similar configuration. The implementation is extensible to support additional special mode in the future with minimal changes and don't create regression on already implemented PHY drivers. (changelog present in single patch) Christian Marangi (5): dt-bindings: net: phy: Make LED active-low property common dt-bindings: net: phy: Document LED inactive high impedance mode net: phy: add support for PHY LEDs polarity modes dt-bindings: net: Document QCA808x PHYs net: phy: at803x: add LED support for qca808x .../devicetree/bindings/leds/common.yaml | 12 + .../bindings/leds/leds-bcm63138.yaml | 4 - .../bindings/leds/leds-bcm6328.yaml | 4 - .../devicetree/bindings/leds/leds-bcm6358.txt | 2 - .../bindings/leds/leds-pwm-multicolor.yaml | 4 - .../devicetree/bindings/leds/leds-pwm.yaml | 5 - .../devicetree/bindings/net/qca,qca808x.yaml | 54 +++ drivers/net/phy/at803x.c | 325 ++++++++++++++++++ drivers/net/phy/phy_device.c | 12 + include/linux/phy.h | 22 ++ 10 files changed, 425 insertions(+), 19 deletions(-) create mode 100644 Documentation/devicetree/bindings/net/qca,qca808x.yaml -- 2.43.0
