Hi,
Am 21.12.23 um 10:56 schrieb Sébastien Szymanski:
Hello Stefan,
On 12/18/23 14:06, Stefan Wahren wrote:
The size-cells for GPMI are wrong in imx28.dtsi, which causes the
following warning:
nand-controller@8000c000: #size-cells:0:0: 0 was expected
The reason for this is the definition of the partitions directly
below the nand controller node. According to nand-controller.yaml
the NAND chip must be defined as a child of the controller. Even
the fixed partitions must be kept in a partitions container.
Signed-off-by: Stefan Wahren <wahrenst@xxxxxxx>
---
Hi,
unfortunately i don't have access to MSR M28CU3 or an Armadeus
Systems APF28
so it would be nice if someone can give a try.
I have tried this patch on an APF28. Unfortunately it doesn't work:
[ 0.000000] Booting Linux on physical CPU 0x0
[ 0.000000] Linux version 6.7.0-rc6 (sszy@gentoo)
(arm-buildroot-linux-gnueabi-gcc.br_real (Buildroot
armadeus-7.0-387-g06d2e893315e-dirty) 12.3.0, GNU ld (GNU Binutils)
2.40) #1 Thu Dec 21 10:24:41 CET 2023
...
[ 4.224482] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xda
[ 4.231238] nand: Micron MT29F2G08ABAEAWP
[ 4.235399] nand: 256 MiB, SLC, erase size: 128 KiB, page size:
2048, OOB size: 64
[ 4.245851] Scanning device for bad blocks
[ 4.252904] Bad eraseblock 0 at 0x000000000000
[ 4.257842] Bad eraseblock 1 at 0x000000020000
[ 4.262972] Bad eraseblock 2 at 0x000000040000
[ 4.267886] Bad eraseblock 3 at 0x000000060000
[ 4.272994] Bad eraseblock 4 at 0x000000080000
[ 4.277900] Bad eraseblock 5 at 0x0000000a0000
[ 4.283007] Bad eraseblock 6 at 0x0000000c0000
[ 4.287916] Bad eraseblock 7 at 0x0000000e0000
[ 5.443712] gpmi-nand: ofpart partition
/apb@80000000/apbh@80000000/nand-controller@8000c000/nand@0
(/apb@80000000/apbh@80000000/nand-controller@8000c000) #size-cells is
wrongly set to <0>, assuming <1> for parsing partitions.
i was too naive by assuming that dt-binding and driver are in sync. I
looked a little bit at the code and DT parsing is done outside of
gpmi-nand by parsers/ofpart_core. So at least the right part is
triggered. Unfortunately the parser seems to look at the wrong node.
Unfortunately i don't have a NAND setup to investigate further. Sorry, i
thought this was a low hanging fruit :-(
[ 5.464436] gpmi-nand: error parsing ofpart partition
/apb@80000000/apbh@80000000/nand-controller@8000c000/nand@0
(/apb@80000000/apbh@80000000/nand-controller@8000c000)
[ 5.523845] gpmi-nand 8000c000.nand-controller: driver registered.
Without this patch:
[ 5.443988] 7 fixed-partitions partitions found on MTD device
gpmi-nand
[ 5.450992] Creating 7 MTD partitions on "gpmi-nand":
[ 5.456234] 0x000000000000-0x000000300000 : "u-boot"
[ 5.506409] 0x000000300000-0x000000380000 : "env"
[ 5.537298] 0x000000380000-0x000000400000 : "env2"
[ 5.568253] 0x000000400000-0x000000480000 : "dtb"
[ 5.598940] 0x000000480000-0x000000500000 : "splash"
[ 5.629766] 0x000000500000-0x000000d00000 : "kernel"
[ 5.661523] 0x000000d00000-0x000010000000 : "rootfs"
[ 5.710012] gpmi-nand 8000c000.nand-controller: driver registered.
Regards,
arch/arm/boot/dts/nxp/mxs/imx28-apf28.dts | 64 +++++++++++++---------
arch/arm/boot/dts/nxp/mxs/imx28-m28.dtsi | 2 -
arch/arm/boot/dts/nxp/mxs/imx28-m28cu3.dts | 28 ++++++----
arch/arm/boot/dts/nxp/mxs/imx28.dtsi | 2 +-
4 files changed, 56 insertions(+), 40 deletions(-)
diff --git a/arch/arm/boot/dts/nxp/mxs/imx28-apf28.dts
b/arch/arm/boot/dts/nxp/mxs/imx28-apf28.dts
index 98672932e41b..10bfac31f672 100644
--- a/arch/arm/boot/dts/nxp/mxs/imx28-apf28.dts
+++ b/arch/arm/boot/dts/nxp/mxs/imx28-apf28.dts
@@ -27,39 +27,49 @@ &gpmi {
pinctrl-0 = <&gpmi_pins_a &gpmi_status_cfg>;
status = "okay";
- partition@0 {
- label = "u-boot";
- reg = <0x0 0x300000>;
- };
+ nand@0 {
+ reg = <0>;
- partition@300000 {
- label = "env";
- reg = <0x300000 0x80000>;
- };
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
- partition@380000 {
- label = "env2";
- reg = <0x380000 0x80000>;
- };
+ partition@0 {
+ label = "u-boot";
+ reg = <0x0 0x300000>;
+ };
- partition@400000 {
- label = "dtb";
- reg = <0x400000 0x80000>;
- };
+ partition@300000 {
+ label = "env";
+ reg = <0x300000 0x80000>;
+ };
- partition@480000 {
- label = "splash";
- reg = <0x480000 0x80000>;
- };
+ partition@380000 {
+ label = "env2";
+ reg = <0x380000 0x80000>;
+ };
- partition@500000 {
- label = "kernel";
- reg = <0x500000 0x800000>;
- };
+ partition@400000 {
+ label = "dtb";
+ reg = <0x400000 0x80000>;
+ };
+
+ partition@480000 {
+ label = "splash";
+ reg = <0x480000 0x80000>;
+ };
+
+ partition@500000 {
+ label = "kernel";
+ reg = <0x500000 0x800000>;
+ };
- partition@d00000 {
- label = "rootfs";
- reg = <0xd00000 0xf300000>;
+ partition@d00000 {
+ label = "rootfs";
+ reg = <0xd00000 0xf300000>;
+ };
+ };
};
};
diff --git a/arch/arm/boot/dts/nxp/mxs/imx28-m28.dtsi
b/arch/arm/boot/dts/nxp/mxs/imx28-m28.dtsi
index 66facef10ba9..54b0f715f091 100644
--- a/arch/arm/boot/dts/nxp/mxs/imx28-m28.dtsi
+++ b/arch/arm/boot/dts/nxp/mxs/imx28-m28.dtsi
@@ -24,8 +24,6 @@ reg_3p3v: regulator-0 {
};
&gpmi {
- #address-cells = <1>;
- #size-cells = <1>;
pinctrl-names = "default";
pinctrl-0 = <&gpmi_pins_a &gpmi_status_cfg>;
status = "okay";
diff --git a/arch/arm/boot/dts/nxp/mxs/imx28-m28cu3.dts
b/arch/arm/boot/dts/nxp/mxs/imx28-m28cu3.dts
index 34b4d3246db1..d069ac907490 100644
--- a/arch/arm/boot/dts/nxp/mxs/imx28-m28cu3.dts
+++ b/arch/arm/boot/dts/nxp/mxs/imx28-m28cu3.dts
@@ -93,21 +93,29 @@ &duart {
};
&gpmi {
- #address-cells = <1>;
- #size-cells = <1>;
pinctrl-names = "default";
pinctrl-0 = <&gpmi_pins_a &gpmi_status_cfg>;
status = "okay";
- partition@0 {
- label = "gpmi-nfc-0-boot";
- reg = <0x00000000 0x01400000>;
- read-only;
- };
+ nand@0 {
+ reg = <0>;
- partition@1 {
- label = "gpmi-nfc-general-use";
- reg = <0x01400000 0x0ec00000>;
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition@0 {
+ label = "gpmi-nfc-0-boot";
+ reg = <0x00000000 0x01400000>;
+ read-only;
+ };
+
+ partition@1 {
+ label = "gpmi-nfc-general-use";
+ reg = <0x01400000 0x0ec00000>;
+ };
+ };
};
};
diff --git a/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
b/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
index 4817fba2d938..9655403b7f90 100644
--- a/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
+++ b/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
@@ -99,7 +99,7 @@ perfmon: perfmon@80006000 {
gpmi: nand-controller@8000c000 {
compatible = "fsl,imx28-gpmi-nand";
#address-cells = <1>;
- #size-cells = <1>;
+ #size-cells = <0>;
reg = <0x8000c000 0x2000>, <0x8000a000 0x2000>;
reg-names = "gpmi-nand", "bch";
interrupts = <41>;
--
2.34.1