The BeagleV Starlight SBC uses a Microchip KSZ9031RNXCA PHY supporting RGMII-ID which doesn't require any particular setup, other than defining a reset gpio, as opposed to VisionFive V1 for which the RX internal delay had to be adjusted. Co-developed-by: Emil Renner Berthing <emil.renner.berthing@xxxxxxxxxxxxx> Signed-off-by: Emil Renner Berthing <emil.renner.berthing@xxxxxxxxxxxxx> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxxxxxx> Reviewed-by: Jacob Keller <jacob.e.keller@xxxxxxxxx> --- .../boot/dts/starfive/jh7100-beaglev-starlight.dts | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts b/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts index 7cda3a89020a..b79426935bfd 100644 --- a/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts +++ b/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts @@ -11,3 +11,14 @@ / { model = "BeagleV Starlight Beta"; compatible = "beagle,beaglev-starlight-jh7100-r0", "starfive,jh7100"; }; + +&mdio { + phy: ethernet-phy@7 { + reg = <7>; + reset-gpios = <&gpio 63 GPIO_ACTIVE_LOW>; + }; +}; + +&gmac { + phy-handle = <&phy>; +}; -- 2.43.0