[PATCH v3 25/29] drm/rockchip: inno_hdmi: Add basic mode validation

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



As per TRM this controller supports pixelclocks starting from 25 MHz. The
maximum supported pixelclocks are defined by the phy configurations we
have. Also it can't support modes that require doubled clocks. If the
variant has a phy reference clock we can additionally validate against VESA
DMT'srecommendations.

Signed-off-by: Alex Bee <knaerzche@xxxxxxxxx>
Reviewed-by: Maxime Ripard <mripard@xxxxxxxxxx>
---
changes in v2:
 - rename inno_mode_valid -> inno_hdmi_display_mode_valid
 - fixed max_tolerance calculation
 - use abs_diff() instead of abs()
 - call in inno_hdmi_display_mode_valid in atomic_check

changes in v3:
 - collect RB

 drivers/gpu/drm/rockchip/inno_hdmi.c | 42 ++++++++++++++++++++++++++--
 1 file changed, 40 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/rockchip/inno_hdmi.c b/drivers/gpu/drm/rockchip/inno_hdmi.c
index 8a1a2320749a..a2a9e54b76c0 100644
--- a/drivers/gpu/drm/rockchip/inno_hdmi.c
+++ b/drivers/gpu/drm/rockchip/inno_hdmi.c
@@ -26,6 +26,8 @@
 
 #include "inno_hdmi.h"
 
+#define INNO_HDMI_MIN_TMDS_CLOCK  25000000U
+
 struct inno_hdmi_phy_config {
 	unsigned long pixelclock;
 	u8 pre_emphasis;
@@ -497,6 +499,38 @@ static int inno_hdmi_setup(struct inno_hdmi *hdmi,
 	return 0;
 }
 
+static enum drm_mode_status inno_hdmi_display_mode_valid(struct inno_hdmi *hdmi,
+							 struct drm_display_mode *mode)
+{
+	unsigned long mpixelclk, max_tolerance;
+	long rounded_refclk;
+
+	/* No support for double-clock modes */
+	if (mode->flags & DRM_MODE_FLAG_DBLCLK)
+		return MODE_BAD;
+
+	mpixelclk = mode->clock * 1000;
+
+	if (mpixelclk < INNO_HDMI_MIN_TMDS_CLOCK)
+		return MODE_CLOCK_LOW;
+
+	if (inno_hdmi_find_phy_config(hdmi, mpixelclk) < 0)
+		return MODE_CLOCK_HIGH;
+
+	if (hdmi->refclk) {
+		rounded_refclk = clk_round_rate(hdmi->refclk, mpixelclk);
+		if (rounded_refclk < 0)
+			return MODE_BAD;
+
+		/* Vesa DMT standard mentions +/- 0.5% max tolerance */
+		max_tolerance = mpixelclk / 200;
+		if (abs_diff((unsigned long)rounded_refclk, mpixelclk) > max_tolerance)
+			return MODE_NOCLOCK;
+	}
+
+	return MODE_OK;
+}
+
 static void inno_hdmi_encoder_enable(struct drm_encoder *encoder,
 				     struct drm_atomic_state *state)
 {
@@ -529,6 +563,7 @@ inno_hdmi_encoder_atomic_check(struct drm_encoder *encoder,
 			       struct drm_connector_state *conn_state)
 {
 	struct rockchip_crtc_state *s = to_rockchip_crtc_state(crtc_state);
+	struct inno_hdmi *hdmi = encoder_to_inno_hdmi(encoder);
 	struct drm_display_mode *mode = &crtc_state->adjusted_mode;
 	u8 vic = drm_match_cea_mode(mode);
 	struct inno_hdmi_connector_state *inno_conn_state =
@@ -549,7 +584,8 @@ inno_hdmi_encoder_atomic_check(struct drm_encoder *encoder,
 	inno_conn_state->rgb_limited_range =
 		drm_default_rgb_quant_range(mode) == HDMI_QUANTIZATION_RANGE_LIMITED;
 
-	return 0;
+	return  inno_hdmi_display_mode_valid(hdmi,
+				&crtc_state->adjusted_mode) == MODE_OK ? 0 : -EINVAL;
 }
 
 static struct drm_encoder_helper_funcs inno_hdmi_encoder_helper_funcs = {
@@ -590,7 +626,9 @@ static enum drm_mode_status
 inno_hdmi_connector_mode_valid(struct drm_connector *connector,
 			       struct drm_display_mode *mode)
 {
-	return MODE_OK;
+	struct inno_hdmi *hdmi = connector_to_inno_hdmi(connector);
+
+	return  inno_hdmi_display_mode_valid(hdmi, mode);
 }
 
 static int
-- 
2.43.0





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux