When qca808x works on the interface mode sgmii or
2500base-x, the interface mode can be switched according
to the PHY link speed.
Signed-off-by: Luo Jie <quic_luoj@xxxxxxxxxxx>
---
drivers/net/phy/at803x.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index b6b41b1a4352..c186ef8e798f 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -2101,10 +2101,22 @@ static void qca808x_link_change_notify(struct phy_device *phydev)
QCA8081_PHY_FIFO_RSTN, phydev->link ? QCA8081_PHY_FIFO_RSTN : 0);
}
+static void qca808x_fill_possible_interfaces(struct phy_device *phydev)
+{
+ unsigned long *possible = phydev->possible_interfaces;
+
+ if (phydev->interface != PHY_INTERFACE_MODE_10G_QXGMII) {
+ __set_bit(PHY_INTERFACE_MODE_2500BASEX, possible);
+ __set_bit(PHY_INTERFACE_MODE_SGMII, possible);
+ }
+}
+
static int qca8084_config_init(struct phy_device *phydev)
{
int ret;
+ qca808x_fill_possible_interfaces(phydev);
+
/* Invert ADC clock edge */
ret = at803x_debug_reg_mask(phydev, QCA8084_ADC_CLK_SEL,
QCA8084_ADC_CLK_SEL_ACLK,
--
2.42.0
