On 08/12/2023 04:38, Bjorn Andersson wrote:
On Thu, Dec 07, 2023 at 05:37:19PM +0100, Neil Armstrong wrote:
diff --git a/arch/arm64/boot/dts/qcom/sm8650.dtsi b/arch/arm64/boot/dts/qcom/sm8650.dtsi
[..]
+
+ mdss_dp0: displayport-controller@af54000 {
+ compatible = "qcom,sm8650-dp";
+ reg = <0 0xaf54000 0 0x200>,
+ <0 0xaf54200 0 0x200>,
+ <0 0xaf55000 0 0xc00>,
+ <0 0xaf56000 0 0x400>,
+ <0 0xaf57000 0 0x400>;
+
+ interrupts-extended = <&mdss 12>;
+
+ clocks = <&dispcc DISP_CC_MDSS_AHB_CLK>,
+ <&dispcc DISP_CC_MDSS_DPTX0_AUX_CLK>,
+ <&dispcc DISP_CC_MDSS_DPTX0_LINK_CLK>,
+ <&dispcc DISP_CC_MDSS_DPTX0_LINK_INTF_CLK>,
+ <&dispcc DISP_CC_MDSS_DPTX0_PIXEL0_CLK>;
+ clock-names = "core_iface",
+ "core_aux",
+ "ctrl_link",
+ "ctrl_link_iface",
+ "stream_pixel";
+
+ assigned-clocks = <&dispcc DISP_CC_MDSS_DPTX0_LINK_CLK_SRC>,
+ <&dispcc DISP_CC_MDSS_DPTX0_PIXEL0_CLK_SRC>;
+ assigned-clock-parents = <&usb_dp_qmpphy QMP_USB43DP_DP_LINK_CLK>,
+ <&usb_dp_qmpphy QMP_USB43DP_DP_VCO_DIV_CLK>;
+
+ operating-points-v2 = <&dp_opp_table>;
+
+ power-domains = <&rpmhpd RPMHPD_MX>;
Are you sure the DP TX block sits in MX? I'd expect this to be
RPMHPD_MMCX, and then the PHY partially in MX...
Hmm, yeah probably, will switch to MMCX
+
+ phys = <&usb_dp_qmpphy QMP_USB43DP_DP_PHY>;
+ phy-names = "dp";
+
+ #sound-dai-cells = <0>;
+
+ status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+
+ mdss_dp0_in: endpoint {
+ remote-endpoint = <&dpu_intf0_out>;
+ };
+ };
+
+ port@1 {
+ reg = <1>;
+
+ mdss_dp0_out: endpoint {
+ };
+ };
+ };
+
+ dp_opp_table: opp-table {
Is there any reason why we keep sorting 'o' after 'p' in these nodes?
No, seems it's a copy-paste issue, will fix
Thanks,
Neil
Regards,
Bjorn
