On Sun, Nov 26, 2023 at 02:53:43AM +0100, Christian Marangi wrote: > From: Robert Marko <robert.marko@xxxxxxxxxx> > > Add DT bindings defined for Qualcomm QCA807x PHY series related to > calibration and DAC settings. > > Signed-off-by: Robert Marko <robert.marko@xxxxxxxxxx> > Signed-off-by: Christian Marangi <ansuelsmth@xxxxxxxxx> > --- > include/dt-bindings/net/qcom-qca807x.h | 30 ++++++++++++++++++++++++++ > 1 file changed, 30 insertions(+) > create mode 100644 include/dt-bindings/net/qcom-qca807x.h How is this used? There's nothing in the binding about it. Binding headers go with the binding schema that define how they are used. > > diff --git a/include/dt-bindings/net/qcom-qca807x.h b/include/dt-bindings/net/qcom-qca807x.h > new file mode 100644 > index 000000000000..e7d4d09b7dd4 > --- /dev/null > +++ b/include/dt-bindings/net/qcom-qca807x.h > @@ -0,0 +1,30 @@ > +/* SPDX-License-Identifier: GPL-2.0-only OR MIT */ > +/* > + * Device Tree constants for the Qualcomm QCA807X PHYs > + */ > + > +#ifndef _DT_BINDINGS_QCOM_QCA807X_H > +#define _DT_BINDINGS_QCOM_QCA807X_H > + > +/* Full amplitude, full bias current */ > +#define QCA807X_CONTROL_DAC_FULL_VOLT_BIAS 0 > +/* Amplitude follow DSP (amplitude is adjusted based on cable length), half bias current */ > +#define QCA807X_CONTROL_DAC_DSP_VOLT_HALF_BIAS 1 > +/* Full amplitude, bias current follow DSP (bias current is adjusted based on cable length) */ > +#define QCA807X_CONTROL_DAC_FULL_VOLT_DSP_BIAS 2 > +/* Both amplitude and bias current follow DSP */ > +#define QCA807X_CONTROL_DAC_DSP_VOLT_BIAS 3 > +/* Full amplitude, half bias current */ > +#define QCA807X_CONTROL_DAC_FULL_VOLT_HALF_BIAS 4 > +/* Amplitude follow DSP setting; 1/4 bias current when cable<10m, > + * otherwise half bias current > + */ > +#define QCA807X_CONTROL_DAC_DSP_VOLT_QUARTER_BIAS 5 > +/* Full amplitude; same bias current setting with “010” and “011”, > + * but half more bias is reduced when cable <10m > + */ > +#define QCA807X_CONTROL_DAC_FULL_VOLT_HALF_BIAS_SHORT 6 > +/* Amplitude follow DSP; same bias current setting with “110”, default value */ > +#define QCA807X_CONTROL_DAC_DSP_VOLT_HALF_BIAS_SHORT 7 > + > +#endif > -- > 2.40.1 >
