Hi everybody, There is a new contactless sensor in Melexis portfolio. MLX90635 is just 1.8x1.8mm in size, but with factory calibration offers instant usage in every project. It offers wide refresh rate range that is configurable between 100ms and 4s. Driver currently provides temperature calculations, power management and changes to the refresh rate. Since sensor is aimed towards the consumer market there is really low number of EEPROM write cycles available, so driver changes refresh rate only in run time registers to avoid writing to EEPROM. Reading EEPROM is not available in Sleep Step mode, so I am using caching at the driver initialization to ensure that measurements can still be taken in Sleep Step mode. Crt Mori (2): iio: temperature: mlx90635 MLX90635 IR Temperature sensor dt-bindings: iio: temperature: add MLX90635 device bindings .../iio/temperature/melexis,mlx90635.yaml | 60 + MAINTAINERS | 7 + drivers/iio/temperature/Kconfig | 12 + drivers/iio/temperature/Makefile | 1 + drivers/iio/temperature/mlx90635.c | 1099 +++++++++++++++++ 5 files changed, 1179 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/temperature/melexis,mlx90635.yaml create mode 100644 drivers/iio/temperature/mlx90635.c -- 2.40.1
