The Hot Plug Detect (HPD) signal for the HDMI display travels from the
on-board HDMI connector, through the IO Expander 1, and finally to the
main_gpio1 line #23, of the SoC.
Add interrupt information for the IO Expander 1 (exp1).
Also add pinmux info of main gpio 1, line #23.
Signed-off-by: Aradhya Bhatia <a-bhatia1@xxxxxx>
---
Notes:
- HDMI display on AM62A7 is not in the mainline yet. All the patches,
including this one, required to enable HDMI display and HPD on
AM62A7 SK-EVM, can be found on my github fork in the branch
"next_am62a-v3"[0].
[0]: https://github.com/aradhya07/linux-ab/tree/next_am62a-v3
arch/arm64/boot/dts/ti/k3-am62a7-sk.dts | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts b/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts
index 8f64ac2c7568..560dad02ef62 100644
--- a/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts
@@ -274,6 +274,12 @@ AM62AX_IOPAD(0x08c, PIN_OUTPUT, 2) /* (K19) GPMC0_WEn.MCASP1_AXR0 */
AM62AX_IOPAD(0x084, PIN_INPUT, 2) /* (L18) GPMC0_ADVn_ALE.MCASP1_AXR2 */
>;
};
+
+ main_gpio1_ioexp_intr_pins_default: main-gpio1-ioexp-intr-default-pins {
+ pinctrl-single,pins = <
+ AM62AX_IOPAD(0x01d4, PIN_INPUT, 7) /* (C15) UART0_RTSn.GPIO1_23 */
+ >;
+ };
};
&mcu_pmx0 {
@@ -407,6 +413,12 @@ exp1: gpio@22 {
reg = <0x22>;
gpio-controller;
#gpio-cells = <2>;
+ interrupt-parent = <&main_gpio1>;
+ interrupts = <23 IRQ_TYPE_EDGE_FALLING>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_gpio1_ioexp_intr_pins_default>;
gpio-line-names = "GPIO_CPSW2_RST", "GPIO_CPSW1_RST",
"BT_EN_SOC", "MMC1_SD_EN",
base-commit: 2220f68f4504aa1ccce0fac721ccdb301e9da32f
--
2.42.0
