[PATCH 3/6] MIPS: NI 169445: Fix NAND GPIOs

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



This changes the GPIOs defined in the device tree to recommended
practice, which is also what the Linux NAND GPIO driver is actually
using.

In the process, fix up the CE and WP lines to be active low, as is
required for proper hardware description.

Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
 arch/mips/boot/dts/ni/169445.dts | 13 +++++++------
 1 file changed, 7 insertions(+), 6 deletions(-)

diff --git a/arch/mips/boot/dts/ni/169445.dts b/arch/mips/boot/dts/ni/169445.dts
index 5389ef46c480..3e7b46d5072c 100644
--- a/arch/mips/boot/dts/ni/169445.dts
+++ b/arch/mips/boot/dts/ni/169445.dts
@@ -1,4 +1,5 @@
 /dts-v1/;
+#include <dt-bindings/gpio/gpio.h>
 
 / {
 	#address-cells = <1>;
@@ -57,18 +58,18 @@ gpio2: gpio@14 {
 			no-output;
 		};
 
-		nand@0 {
+		nand-controller@0 {
 			compatible = "gpio-control-nand";
 			nand-on-flash-bbt;
 			nand-ecc-mode = "soft_bch";
 			nand-ecc-step-size = <512>;
 			nand-ecc-strength = <4>;
 			reg = <0x0 4>;
-			gpios = <&gpio2 0 0>, /* rdy */
-				<&gpio1 1 0>, /* nce */
-				<&gpio1 2 0>, /* ale */
-				<&gpio1 3 0>, /* cle */
-				<&gpio1 4 0>; /* nwp */
+			rdy-gpios = <&gpio2 0 GPIO_ACTIVE_HIGH>;
+			ce-gpios = <&gpio1 1 GPIO_ACTIVE_LOW>;
+			ale-gpios = <&gpio1 2 GPIO_ACTIVE_HIGH>;
+			cle-gpios = <&gpio1 3 GPIO_ACTIVE_HIGH>;
+			wp-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>;
 		};
 
 		serial@80000 {

-- 
2.34.1





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux