On PMICs such as PM8350C, the pattern lookup table (LUT) is stored in a
separate SDAM from the one where the lpg per-channel data is stored.
Add support for PPG with a dedicated LUT SDAM while maintaining backward
compatibility for those targets that use only a single SDAM.
Co-developed-by: Guru Das Srinagesh <quic_gurus@xxxxxxxxxxx>
Signed-off-by: Guru Das Srinagesh <quic_gurus@xxxxxxxxxxx>
Signed-off-by: Anjelique Melendez <quic_amelende@xxxxxxxxxxx>
Reviewed-by: Lee Jones <lee@xxxxxxxxxx>
---
drivers/leds/rgb/leds-qcom-lpg.c | 92 +++++++++++++++++++++++++++-----
1 file changed, 78 insertions(+), 14 deletions(-)
diff --git a/drivers/leds/rgb/leds-qcom-lpg.c b/drivers/leds/rgb/leds-qcom-lpg.c
index 92fee512d965..fdf453aa3859 100644
--- a/drivers/leds/rgb/leds-qcom-lpg.c
+++ b/drivers/leds/rgb/leds-qcom-lpg.c
@@ -42,6 +42,8 @@
#define PWM_DTEST_REG(x) (0xe2 + (x) - 1)
#define SDAM_REG_PBS_SEQ_EN 0x42
+#define SDAM_PBS_TRIG_SET 0xe5
+#define SDAM_PBS_TRIG_CLR 0xe6
#define TRI_LED_SRC_SEL 0x45
#define TRI_LED_EN_CTL 0x46
@@ -60,8 +62,12 @@
#define DEFAULT_TICK_DURATION_US 7800
#define RAMP_STEP_DURATION(x) (((x) * 1000 / DEFAULT_TICK_DURATION_US) & 0xff)
+#define SDAM_MAX_DEVICES 2
/* LPG common config settings for PPG */
+#define SDAM_START_BASE 0x40
#define SDAM_REG_RAMP_STEP_DURATION 0x47
+
+#define SDAM_LUT_SDAM_LUT_PATTERN_OFFSET 0x45
#define SDAM_LPG_SDAM_LUT_PATTERN_OFFSET 0x80
/* LPG per channel config settings for PPG */
@@ -70,6 +76,8 @@
#define SDAM_END_INDEX_OFFSET 0x3
#define SDAM_START_INDEX_OFFSET 0x4
#define SDAM_PBS_SCRATCH_LUT_COUNTER_OFFSET 0x6
+#define SDAM_PAUSE_HI_MULTIPLIER_OFFSET 0x8
+#define SDAM_PAUSE_LO_MULTIPLIER_OFFSET 0x9
struct lpg_channel;
struct lpg_data;
@@ -86,6 +94,7 @@ struct lpg_data;
* @lut_bitmap: allocation bitmap for LUT entries
* @pbs_dev: PBS device
* @lpg_chan_sdam: LPG SDAM peripheral device
+ * @lut_sdam: LUT SDAM peripheral device
* @pbs_en_bitmap: bitmap for tracking PBS triggers
* @triled_base: base address of the TRILED block (optional)
* @triled_src: power-source for the TRILED
@@ -110,6 +119,7 @@ struct lpg {
struct pbs_dev *pbs_dev;
struct nvmem_device *lpg_chan_sdam;
+ struct nvmem_device *lut_sdam;
unsigned long pbs_en_bitmap;
u32 triled_base;
@@ -249,6 +259,13 @@ static int lpg_clear_pbs_trigger(struct lpg *lpg, unsigned int lut_mask)
rc = nvmem_device_write(lpg->lpg_chan_sdam, SDAM_REG_PBS_SEQ_EN, 1, &val);
if (rc < 0)
return rc;
+
+ if (lpg->lut_sdam) {
+ val = PBS_SW_TRIG_BIT;
+ rc = nvmem_device_write(lpg->lpg_chan_sdam, SDAM_PBS_TRIG_CLR, 1, &val);
+ if (rc < 0)
+ return rc;
+ }
}
return 0;
@@ -264,9 +281,15 @@ static int lpg_set_pbs_trigger(struct lpg *lpg, unsigned int lut_mask)
if (rc < 0)
return rc;
- rc = qcom_pbs_trigger_event(lpg->pbs_dev, val);
- if (rc < 0)
- return rc;
+ if (lpg->lut_sdam) {
+ rc = nvmem_device_write(lpg->lpg_chan_sdam, SDAM_PBS_TRIG_SET, 1, &val);
+ if (rc < 0)
+ return rc;
+ } else {
+ rc = qcom_pbs_trigger_event(lpg->pbs_dev, val);
+ if (rc < 0)
+ return rc;
+ }
}
lpg->pbs_en_bitmap |= lut_mask;
@@ -313,8 +336,15 @@ static int lpg_lut_store_sdam(struct lpg *lpg, struct led_pattern *pattern,
for (i = 0; i < len; i++) {
brightness = pattern[i].brightness;
- addr = SDAM_LPG_SDAM_LUT_PATTERN_OFFSET + i + idx;
- rc = nvmem_device_write(lpg->lpg_chan_sdam, addr, 1, &brightness);
+
+ if (lpg->lut_sdam) {
+ addr = SDAM_LUT_SDAM_LUT_PATTERN_OFFSET + i + idx;
+ rc = nvmem_device_write(lpg->lut_sdam, addr, 1, &brightness);
+ } else {
+ addr = SDAM_LPG_SDAM_LUT_PATTERN_OFFSET + i + idx;
+ rc = nvmem_device_write(lpg->lpg_chan_sdam, addr, 1, &brightness);
+ }
+
if (rc < 0)
return rc;
}
@@ -581,13 +611,28 @@ static void lpg_sdam_apply_lut_control(struct lpg_channel *chan)
struct nvmem_device *lpg_chan_sdam = chan->lpg->lpg_chan_sdam;
unsigned int lo_idx = chan->pattern_lo_idx;
unsigned int hi_idx = chan->pattern_hi_idx;
- u8 val = 0, conf = 0;
+ u8 val = 0, conf = 0, lut_offset = 0;
+ unsigned int hi_pause, lo_pause;
+ struct lpg *lpg = chan->lpg;
if (!chan->ramp_enabled || chan->pattern_lo_idx == chan->pattern_hi_idx)
return;
+ hi_pause = DIV_ROUND_UP(chan->ramp_hi_pause_ms, chan->ramp_tick_ms);
+ lo_pause = DIV_ROUND_UP(chan->ramp_lo_pause_ms, chan->ramp_tick_ms);
+
if (!chan->ramp_oneshot)
conf |= LPG_PATTERN_CONFIG_REPEAT;
+ if (chan->ramp_hi_pause_ms && lpg->lut_sdam)
+ conf |= LPG_PATTERN_CONFIG_PAUSE_HI;
+ if (chan->ramp_lo_pause_ms && lpg->lut_sdam)
+ conf |= LPG_PATTERN_CONFIG_PAUSE_LO;
+
+ if (lpg->lut_sdam) {
+ lut_offset = SDAM_LUT_SDAM_LUT_PATTERN_OFFSET - SDAM_START_BASE;
+ hi_idx += lut_offset;
+ lo_idx += lut_offset;
+ }
nvmem_device_write(lpg_chan_sdam, SDAM_PBS_SCRATCH_LUT_COUNTER_OFFSET + chan->sdam_offset, 1, &val);
nvmem_device_write(lpg_chan_sdam, SDAM_PATTERN_CONFIG_OFFSET + chan->sdam_offset, 1, &conf);
@@ -596,6 +641,12 @@ static void lpg_sdam_apply_lut_control(struct lpg_channel *chan)
val = RAMP_STEP_DURATION(chan->ramp_tick_ms);
nvmem_device_write(lpg_chan_sdam, SDAM_REG_RAMP_STEP_DURATION, 1, &val);
+
+ if (lpg->lut_sdam) {
+ nvmem_device_write(lpg_chan_sdam, SDAM_PAUSE_HI_MULTIPLIER_OFFSET + chan->sdam_offset, 1, &hi_pause);
+ nvmem_device_write(lpg_chan_sdam, SDAM_PAUSE_LO_MULTIPLIER_OFFSET + chan->sdam_offset, 1, &lo_pause);
+ }
+
}
static void lpg_apply_lut_control(struct lpg_channel *chan)
@@ -979,7 +1030,8 @@ static int lpg_pattern_set(struct lpg_led *led, struct led_pattern *led_pattern,
* enabled. In this scenario the delta_t of the middle entry (i.e. the
* last in the programmed pattern) determines the "high pause".
*
- * SDAM-based devices do not support "ping-pong", "low pause" or "high pause"
+ * SDAM-based devices do not support "ping pong", and only supports
+ * "low pause" and "high pause" with a dedicated SDAM LUT.
*/
/* Detect palindromes and use "ping pong" to reduce LUT usage */
@@ -1024,9 +1076,10 @@ static int lpg_pattern_set(struct lpg_led *led, struct led_pattern *led_pattern,
/*
* Find "low pause" and "high pause" in the pattern in the LUT case.
- * SDAM-based devices require equal duration of all steps
+ * SDAM-based devices without dedicated LUT SDAM require equal
+ * duration of all steps.
*/
- if (lpg->lut_base) {
+ if (lpg->lut_base || lpg->lut_sdam) {
lo_pause = pattern[0].delta_t;
hi_pause = pattern[actual_len - 1].delta_t;
} else {
@@ -1492,17 +1545,28 @@ static int lpg_init_sdam(struct lpg *lpg)
sdam_count = of_property_count_strings(lpg->dev->of_node, "nvmem-names");
if (sdam_count <= 0)
return 0;
+ if (sdam_count > SDAM_MAX_DEVICES)
+ return -EINVAL;
- /* Get the SDAM device for LPG/LUT config */
+ /* Get the 1st SDAM device for LPG/LUT config */
lpg->lpg_chan_sdam = devm_nvmem_device_get(lpg->dev, "lpg_chan_sdam");
if (IS_ERR(lpg->lpg_chan_sdam))
return dev_err_probe(lpg->dev, PTR_ERR(lpg->lpg_chan_sdam),
"Failed to get LPG chan SDAM device\n");
- lpg->pbs_dev = get_pbs_client_device(lpg->dev);
- if (IS_ERR(lpg->pbs_dev))
- return dev_err_probe(lpg->dev, PTR_ERR(lpg->pbs_dev),
- "Failed to get PBS client device\n");
+ if (sdam_count == 1) {
+ /* Get PBS device node if single SDAM device */
+ lpg->pbs_dev = get_pbs_client_device(lpg->dev);
+ if (IS_ERR(lpg->pbs_dev))
+ return dev_err_probe(lpg->dev, PTR_ERR(lpg->pbs_dev),
+ "Failed to get PBS client device\n");
+ } else if (sdam_count == 2) {
+ /* Get the 2nd SDAM device for LUT pattern */
+ lpg->lut_sdam = devm_nvmem_device_get(lpg->dev, "lut_sdam");
+ if (IS_ERR(lpg->lut_sdam))
+ return dev_err_probe(lpg->dev, PTR_ERR(lpg->lut_sdam),
+ "Failed to get LPG LUT SDAM device\n");
+ }
for (i = 0; i < lpg->num_channels; i++) {
struct lpg_channel *chan = &lpg->channels[i];
--
2.41.0
