KSZ switches with WoL support signals wake event over PME pin. If this
pin is attached to some external PMIC or System Controller can't be
described as GPIO, the only way to describe it in the devicetree is to
use wakeup-source property. So, add support for this property and enable
PME switch output if this property is present.
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
Reviewed-by: Andrew Lunn <andrew@xxxxxxx>
Reviewed-by: Florian Fainelli <florian.fainelli@xxxxxxxxxxxx>
---
drivers/net/dsa/microchip/ksz_common.c | 3 +++
drivers/net/dsa/microchip/ksz_common.h | 1 +
2 files changed, 4 insertions(+)
diff --git a/drivers/net/dsa/microchip/ksz_common.c b/drivers/net/dsa/microchip/ksz_common.c
index 02fab1adb27f..11adae8a2037 100644
--- a/drivers/net/dsa/microchip/ksz_common.c
+++ b/drivers/net/dsa/microchip/ksz_common.c
@@ -4159,6 +4159,9 @@ int ksz_switch_register(struct ksz_device *dev)
dev_err(dev->dev, "inconsistent synclko settings\n");
return -EINVAL;
}
+
+ dev->wakeup_source = of_property_read_bool(dev->dev->of_node,
+ "wakeup-source");
}
ret = dsa_register_switch(dev->ds);
diff --git a/drivers/net/dsa/microchip/ksz_common.h b/drivers/net/dsa/microchip/ksz_common.h
index 8842efca0871..f7c471bc040f 100644
--- a/drivers/net/dsa/microchip/ksz_common.h
+++ b/drivers/net/dsa/microchip/ksz_common.h
@@ -163,6 +163,7 @@ struct ksz_device {
phy_interface_t compat_interface;
bool synclko_125;
bool synclko_disable;
+ bool wakeup_source;
struct vlan_table *vlan_cache;
--
2.39.2
