On Thu, Oct 12, 2023 at 01:55:36PM -0700, Stephen Boyd wrote:
> Quoting Varadarajan Narayanan (2023-10-12 02:26:17)
> > Stromer plus APSS PLL does not support dynamic frequency scaling.
> > To switch between frequencies, we have to shut down the PLL,
> > configure the L and ALPHA values and turn on again. So introduce the
> > separate set of ops for Stromer Plus PLL.
>
> Does this assume the PLL is always on?
Yes once the PLL is configured by apss-ipq-pll driver, it is always on.
> > Signed-off-by: Kathiravan T <quic_kathirav@xxxxxxxxxxx>
> > Signed-off-by: Varadarajan Narayanan <quic_varada@xxxxxxxxxxx>
> > ---
> > v2: Use clk_alpha_pll_stromer_determine_rate, instead of adding new
> > clk_alpha_pll_stromer_plus_determine_rate as the alpha pll width
> > is same for both
> >
> > Fix review comments
> > udelay(50) -> usleep_range(50, 60)
> > Remove SoC-specific from print message
> > ---
> > drivers/clk/qcom/clk-alpha-pll.c | 57 ++++++++++++++++++++++++++++++++++++++++
> > drivers/clk/qcom/clk-alpha-pll.h | 1 +
> > 2 files changed, 58 insertions(+)
> >
> > diff --git a/drivers/clk/qcom/clk-alpha-pll.c b/drivers/clk/qcom/clk-alpha-pll.c
> > index 4edbf77..5221b6c 100644
> > --- a/drivers/clk/qcom/clk-alpha-pll.c
> > +++ b/drivers/clk/qcom/clk-alpha-pll.c
> > @@ -2508,3 +2508,60 @@ const struct clk_ops clk_alpha_pll_stromer_ops = {
> > .set_rate = clk_alpha_pll_stromer_set_rate,
> > };
> > EXPORT_SYMBOL_GPL(clk_alpha_pll_stromer_ops);
> > +
> > +static int clk_alpha_pll_stromer_plus_set_rate(struct clk_hw *hw,
> > + unsigned long rate,
> > + unsigned long prate)
> > +{
> > + struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
> > + u32 l, alpha_width = pll_alpha_width(pll);
> > + int ret;
> > + u64 a;
> > +
> > + rate = alpha_pll_round_rate(rate, prate, &l, &a, alpha_width);
> > +
> > + regmap_write(pll->clkr.regmap, PLL_MODE(pll), 0);
>
> There's a theoretical problem here if I understand correctly. A call to
> clk_enable() can happen while clk_set_rate() is in progress or vice
> versa. Probably we need some sort of spinlock for this PLL that
> synchronizes any enable/disable with the rate change so that when we
> restore the enable bit the clk isn't enabled when it was supposed to be
> off.
Since the PLL is always on, should we worry about enable/disable?
If you feel it is better to synchronize with a spin lock, will
add and post a new revision. Please let me know.
Thanks
Varada
