Re: [PATCH V5 3/4] hwmon: ina3221: Add support for channel summation disable

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Jean, Guenter,

On 29/09/2023 11:36, Jon Hunter wrote:
From: Ninad Malwade <nmalwade@xxxxxxxxxx>

The INA3221 allows the Critical alert pin to be controlled by the
summation control function. This function adds the single
shunt-voltage conversions for the desired channels in order to compare
the combined sum to the programmed limit. The Shunt-Voltage Sum Limit
register contains the programmed value that is compared to the value in
the Shunt-Voltage Sum register in order to determine if the total summed
limit is exceeded. If the shunt-voltage sum limit value is exceeded, the
Critical alert pin pulls low.

For the summation limit to have a meaningful value, we have to use the
same shunt-resistor value on all included channels. Unless equal
shunt-resistor values are used for each channel, the summation control
function cannot be used and it is not enabled by the driver.

To address this, add support to disable the summation of specific
channels via device tree property "ti,summation-disable". The channel
which has this property would be excluded from the calculation of
summation control function.

For example, summation control function calculates Shunt-Voltage Sum as:

- input_shunt_voltage_summation = input_shunt_voltage_channel1
                                 + input_shunt_voltage_channel2
                                 + input_shunt_voltage_channel3

If we want the summation to only use channel1 and channel3, we can add
'ti,summation-disable' property in device tree node for channel2. Then
the calculation will skip channel2.

- input_shunt_voltage_summation = input_shunt_voltage_channel1
                                 + input_shunt_voltage_channel3

Note that we only want the channel to be skipped for summation control
function rather than completely disabled. Therefore, even if we add the
property 'ti,summation-disable', the channel is still enabled and
functional.

Finally, create debugfs entries that display if summation is disabled
for each of the channels.

Signed-off-by: Rajkumar Kasirajan <rkasirajan@xxxxxxxxxx>
Signed-off-by: Ninad Malwade <nmalwade@xxxxxxxxxx>
Co-developed-by: Jon Hunter <jonathanh@xxxxxxxxxx>
Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx>


Any feedback on this?

Thanks
Jon

--
nvpublic




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux