On 05/10/2023 05:55, Chanh Nguyen wrote:
> Use gpio-leds to configure GPIOW5 to GPIO_ACTIVE_HIGH and
> GPIO_TRANSITORY flags as a bmc ready led. The GPIOW5 pin
> is reset when watchdog timeout occurs.
>
> Configure the GPIOS3 to GPIO_ACTIVE_HIGH as an identify led.
>
> Signed-off-by: Chanh Nguyen <chanh@xxxxxxxxxxxxxxxxxxxxxx>
> ---
> .../dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts | 13 +++++++++++++
> 1 file changed, 13 insertions(+)
>
> diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts
> index b7c4f7cfad07..88693c2b2dbe 100644
> --- a/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts
> +++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts
> @@ -51,6 +51,19 @@
> };
> };
>
> + leds {
> + compatible = "gpio-leds";
> +
> + bmc-ready {
Missing led name.
It does not look like you tested the DTS against bindings. Please run
`make dtbs_check W=1` (see
Documentation/devicetree/bindings/writing-schema.rst or
https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
for instructions).
Best regards,
Krzysztof
