The pinmux for LED3 and LED4 are incorrectly attached to the
omap3_pmx_core when they should be connected to the omap3_pmx_wkup
pin mux. This was likely masked by the fact that the bootloader
used to do all the pinmuxing.
Fixes: 0dbf99542caf ("ARM: dts: am3517-evm: Add User LEDs and Pushbutton")
Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
---
V3: No Change
V2: Use current device tree naming convention for led-pins
This likely will require a separate patch to apply to previous file location.
diff --git a/arch/arm/boot/dts/ti/omap/am3517-evm.dts b/arch/arm/boot/dts/ti/omap/am3517-evm.dts
index af9df15274be..866f68c5b504 100644
--- a/arch/arm/boot/dts/ti/omap/am3517-evm.dts
+++ b/arch/arm/boot/dts/ti/omap/am3517-evm.dts
@@ -271,13 +271,6 @@ OMAP3_CORE1_IOPAD(0x21c4, PIN_INPUT_PULLUP | MUX_MODE0) /* i2c3_sda */
>;
};
- leds_pins: leds-pins {
- pinctrl-single,pins = <
- OMAP3_WKUP_IOPAD(0x2a24, PIN_OUTPUT_PULLUP | MUX_MODE4) /* jtag_emu0.gpio_11 */
- OMAP3_WKUP_IOPAD(0x2a26, PIN_OUTPUT_PULLUP | MUX_MODE4) /* jtag_emu1.gpio_31 */
- >;
- };
-
mmc1_pins: mmc1-pins {
pinctrl-single,pins = <
OMAP3_CORE1_IOPAD(0x2144, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc1_clk.sdmmc1_clk */
@@ -355,3 +348,12 @@ OMAP3430_CORE2_IOPAD(0x25e2, PIN_INPUT | MUX_MODE3) /* etk_d3.hsusb1_data7 */
>;
};
};
+
+&omap3_pmx_wkup {
+ leds_pins: leds-pins {
+ pinctrl-single,pins = <
+ OMAP3_WKUP_IOPAD(0x2a24, PIN_OUTPUT_PULLUP | MUX_MODE4) /* jtag_emu0.gpio_11 */
+ OMAP3_WKUP_IOPAD(0x2a26, PIN_OUTPUT_PULLUP | MUX_MODE4) /* jtag_emu1.gpio_31 */
+ >;
+ };
+};
--
2.40.1
